资源列表
New-WinRAR-ZIP-archive
- gsm interfacing for 8051 microcontroller
Wg34ReceiveProgram
- 这是一个运行在51单片机的WG34接收程序，使用的查询算法，在调用时关闭所有中断可以使接收程序更稳定。-This is a run in 51 single WG34 receiving procedures, the use of query algorithm, called off all interrupts can make the program more stable reception.
ESCROW_CANBOX.tar
- ELM327 INTERFACED WITH 8051 CIRCUIT AND READING VEHICLE PARAMETERS IN KEIL
AD7705
- 该代码为ad7705 AD转换，本人已调试成功。控制芯片为ATMEGA16-The code for ad7705 AD conversion, I have debugged. Control chip for the ATMEGA16
touch-key
- mcsp430 touch key source-msp430 touch key source
Adjustable-electronic-
- 用DS1302与数码管设计的可调电子钟 单片机C语言源代码+proteus仿真图-Adjustable electronic clock using DS1302 with digital tube
MPU6050
- Interfacing PIC using MikroC to MPU6050
CH376_CODE
- CH376 U盘控制芯片驱动，在FPGA的SOPC平台上调试的，也可以稍加修改就可用在单片机上，串口、SPI、并口三种通信接口选择。-CH376 U disk drive controller chip, the SOPC platform on FPGA debugging can also be slightly modified can be used on single-chip, serial, SPI, three parallel communication interface s
adm3053brwz
- CAN总线物理收发接口模块adm3053的仿真模型，可用于设计仿真-CAN bus physical transceiver interface module adm3053 simulation model can be used for design and simulation
lesson-1
- 通过使用51单片机系列对两相四线步进电机实现基本控制与运动-By using 51 single-family on two-phase four-wire stepper motor to achieve the basic control and motion
parallel
- parallel connected pFC controller ac to dc dc to dc converter
step-motor-testing
- 单片机开发板5轴步进电机联动-模拟数控系统测试-Microcontroller development board 5-axis stepper motor linkage- CNC system simulation test