资源列表
51-555
- 用555芯片产生并输出等间隔连续脉冲、断续波脉冲、幅度调制脉冲三种波形发生电路以及电压和电流输出电路，通过通过单片机控制选择不同的治疗刺激脉冲序列的输出、控制治疗时间-555 chip generates and outputs interval continuous pulse the intermittent wave pulse, amplitude modulated pulse the three waveform generation circuit and the voltage
CC2530UART2Test
- cc2530 串口接收程序 中间有接收中断操作，结合datasheet调整波特率可直接使用-cc2530 serial middle of the receiving program receive interrupt operation, combined datasheet adjust baud rate can be used directly
Shift_register
- Simulation usin Proteus an AVR Atmega328p and ShiftRegister to controller relays.
Uart_com
- 本程序为STC89C52与PC机超级终端通讯的实验程序 在PC机键盘上输入字符，单片机接收，并发送回PC机，显示在超级 终端；超级终端配置为：波特率为9600，数据位8，奇偶校验：无 停止位：1；硬件：无-This program is STC89C52 communication with the PC HyperTerminal experimental procedures on the PC keyboard to enter characters, single-chip
BOOM
- 简易炸弹原理，仅作为娱乐，请勿用于不法道路-The simple bombs principle, only as entertainment, do not for illegal road
Smart-house.SUST.shrbot
- smart home automation-smart home automation
SerialStepMotor
- 这是我刚做的一个小项目，计算机通过串口控制步进电机的C51程序-This is what I have just done a small project, the computer controlled stepper motor through the serial port C51 program
portsimultan
- port simulation usinf vb
DS1802
- c51控制ds1820在1602上显示温度-C51 control ds1820 in 1602 to show the temperature
msp430pwm
- msp430f basic pwm outsoucing
sdfv
- New program tested for checking touch screen controller
Timer1CapToControlLED
- LPC213X开发板提供的定时器1输入捕获实验,基于前后台的实验.