资源列表
adc
- ADC0809 0-5V电压表显示程序（共阴）-ADC0809 He is good
proc
- 单片机实现458总线现场监测系统的C程序设计-MCU 458 bus on-site monitoring system of the C programming
lgc
- 嵌入式的简单开发源码示例，较好的入门程序例子
motorControlProteus
- 电机控制正反转proteus仿真 可以-proteus simulation of motor control
lcdoficial8biti
- Command a FORDATA LCD MODULE using a MSP430f149 microcontroler from TI using 4 bits interface and timer
spc3_Slave
- profibus-DP智能从站开发程序源代码,C语言写的-Profibus- DP intelligent slave to the development of program source code written in C language
AD9244 (ADC)
- 用BF533的AD程序-BF533 with the procedures AD
IrDAPro
- 基于单片机红外通信传输，包括程序和原理图-Based on single-chip infrared communication transmission, including program and schematic
SC_9-0
- there is no start key,the scanning is on contineously. dpsel1=00h AC VOLT dpsel2=00h AC CURRENT dpsel3=00h PREASURE 1 dpsel4=00h PREASURE 2 Scanning on display stops only when in set mode otherwise it is on. This Progra
628a
- 基于PIC16f628a单片机控制的RLC智能测量仪,原理图，源码-Control RLC based PIC16f628a microcontroller smart meter, schematics, source...
ps2
- 通过在PS2上进行按键输入，然后串口通信，使数码管显示编码后的数值-By performing key input on the PS2, and serial communication, so that the digital display values encoded
IR_Library
- IrCrtl module is an IR remote control protocol driver. It supports three major communication formats in Japan, NEC, AEHA and SONY.