资源列表
crc16IEE
- CRC16IEE校验程序,很有用,采用比特输入.并将编码和译码写在一个程序中,直接可以用-CRC16IEE verification procedures, is useful, the use of bit input. And written in the encoding and decoding a program, can be used directly
yuanma
- 1 SPI接口EEPROM的控制 2 SPI总线在单片机系统中的实现 3 基于RS-232的串口通信 4 FLASH存储器K9F6408U0A的控制 5 I2C接口EEPROM——AT24C512-1 SPI interface EEPROM Control 2 SPI bus system in the realization of single-chip 3-based RS-232 Serial Communication 4 FLASH memory
thermal-printer
- thermal printer this was intended to be usable and I actually built it up, in practise it was way too slow, this code does stepper motor control, thermal printhead control and an attempt at reading data from a parallel port that mostly worked. -t
lcd_11
- 这是一个完整的C51源程序，我觉得对一位初学C51 的人来说，提供一个完整的简单程序比较容易上手。
STM32-ILI9320-touch
- 基于STM32的触摸屏初始化，ili9320，320*240的触摸屏。-STM32-based touchscreen initialization, ili9320, 320* 240 touch screen.
PIC32MXx40-pinout.xls
- A pinout helper that allows you to easily create your pin allocations for PIC32MX3xxx processors!
CAN
- 局域网CAN控制器MCP2515源程序，这里是通过NIOSII控制的代码-LAN CAN controller MCP2515 source code is through NIOSII control
exp-2d
- DSP，C5416图像处理，将图像进行反色处理和将彩色图像进行二值化处理-DSP, C5416 image processing, image processing and the anti-color color image binarization
user
- 利用ADC的第11通道对开发板输入的电压值作AD转换，采用连续转换模式，转换结果通过DMA通道1读取,ADC转换的结果，每间隔1秒钟向串口发送一次. -The first 11-channel ADC input voltage value on the development board for the AD converter, continuous conversion mode, the conversion result by the DMA channel reads the A
Atmega88-Uart
- Debug with uart c++ example for ATmega88.
C8051F040-SPI
- C8051F040的SPI通讯例程，调试完毕，可用-C8051F040 SPI communication routines, debugging is completed, available
FFT
- 此函数是通用的快速傅里叶变换C语言函数，移植性强，以下部分不依 赖硬件。此函数采用联合体的形式表示一个复数，输入为自然顺序的复 数（输入实数是可令复数虚部为0），输出为经过FFT变换的自然顺序的 复数 -This function is a generic fast Fourier transform C language function, strong transplantation, the following section is not dependent on