资源列表
pwm
- PWM信号发生及测量仪（50Hz，10~90 占空比可调节） P23输出、P32输入；前两位显示输出占空比，后两位显示输入的测量值 -PWM signal generation and measurement (50Hz, 10 ~ 90 duty cycle adjustable) P23 output, P32 input two shows the output duty cycle, the latter two show the measured value input
msp430-C
- 程序功能：MCU不停向PC机发送数据,在屏幕上显示0~127对应的ASCII字符-Program features: MCU stop sending data to a PC, displayed on the screen corresponding to 0 to 127 ASCII characters
GBASCREEN
- 这是一个关于在ＧＢＡ上显示文字的程序，如果大家有兴趣可以一看，现在给大家共享一下.-this is a GBA on the text displayed on the procedure, if you are interested, you should have a look now to share this.
spi
- 软件模拟SPI串行EEPROM控制时序的C程序，在DOS下用BC31编译
test
- Testprogram TRF7960 test
key
- 基于STM32系列芯片的4*8矩阵键盘扫描程序，采用定时器消抖，扫描效率高。-4* 8 matrix keyboard scanning procedures based on the STM32 series chips , using timer to debounce , high scanning efficiency.
Photosensitive-sensor
- 光敏电阻器是利用半导体的光电效应制成的一种电阻值随入射光的强弱而改变的电阻器；入射光强，电阻减小，入射光弱，电阻增大。本程序是基于MSP430的光敏传感器的模块程序-Photosensitive resistor is made using the photoelectric effect of the semiconductor a resistance change with the strength of the incident light and the resistor The i
9e5
- Copyright (C) 2004 Nordic Semiconductor ; ; This file is distributed in the hope that it will be useful, but WITHOUT ; WARRANTY OF ANY KIND. ; ; ; Author(s): Ole Saether ; ; DEscr iptION: ; ; nRF9E5 Hello World program. Please note that th
MB90092
- 用KEIL_C51写的富士通MB90092的驱动程序！-KEIL_C51 write with Fujitsu MB90092 drivers!
LogicChecker
- Application for PIC18 microprocessor used to test logic of another device.
debug_uart
- UART串口应用程序LPC1768 源代码-failed to translate
main
- 加速度计的16位置补偿算法的c++实现，计算误差补偿系数，增加加速度计的精度。-Accelerometer 16 c++ position compensation algorithm implemented calculate the compensation factor, increase the accuracy of the accelerometer.