资源列表
atmega16.rar
- atmega16 定时器1 两路 pwm交替输出 方法 可用来驱动半桥,atmega16 Timer a two-way alternating pwm output method can be used to drive the half-bridge
pwm
- NIOS上的PWM代码 硬件实现 实现了可自由定义的，自定义相位，自定义死去时间，自定义占空比-NIOS code on the hardware PWM to achieve a free-defined, custom phase, custom die time, the custom duty
18b20
- 18b20 时序图 对于初学者还是不错的-18b20 timer series
beep
- 八月桂花，蜂鸣器，基于C51单片机，C语言源程序-August osmanthus, buzzer, C51-based Microcontroller
SweepGenerator
- This is a working Sweep-Generator CCS C Programm. It runs on pic24 and dsPIC33. It controls the AD9850 DDS board connected in serial mode via pin data_7. There are 3 buttons that control the program state. Two led diodes on pin_b2 and pin_b3 indicate
main
- 接口技术键盘阵列实验，通过proteus模拟，按下一个键，led灯会闪烁该键号的次数。-the key
msp430x41x2_uscia0_uart_06_9600
- MSP430F41X2 UART 异步通讯例程-MSP430F41X2 UART asynchronous communication routines
DHT11Source
- DHT11温湿度传感器在cc2530中的驱动-DHT11 for cc2530 in z-stack
ASS58N
- 把格雷码转换成十六进制的C语言程序,用来读取编码器的值-Gray code put into hexadecimal C Programming Language, used to read the value encoder
16adc
- mage16的ad实验程序已经在16实验板上验证成功了-mage16 the ad experimental procedure has been verified in the 16 experiments on-board success
LAMP3
- 此程序主要实现在十字路口，东西南北交通灯实现倒计时的功能。-The procedure to achieve at the crossroads, East and West traffic lights to achieve the function of the countdown.
16F-CCP-a-TIMER1
- Interrupt based Program