资源列表
IAR_MSP430_LPM
- MSP430 LPM SOURCE CODE FOR IAR
main
- 用c语言编写的2119检测程序代码 简单易懂 -2119 using c language test program is straightforward
BCDcoder
- 关于三位数的BCD转二进制，和二进制转BCD码。用verilog编写-BCD to Binary and Binary to BCD
trafflyt
- This program has been written for PIC16f877 microcontroller. This program control the Traffic signals automatically upon detection of vehicles by using IR sensors
main
- 针对430单片机，通过定义位结构和联合的方式实现直接对单片机寄存器中某一位进行操作-For 430 microcontroller, by defining the structure and mode bits combined direct register a bit microcontroller operation
DS18B20gai
- 实现对DS18B20的读取,注意：单总线协议对延时要求比较严格，此程序中采用的是11.0592M的晶振，如果使用其他的晶振请跟据DS18B20的资料修改延时参数 -DS18B20 achieve the right read, attention : single bus protocol to delay more stringent requirements, This procedure is used in the M 11.0592 Crystal Oscillator, If y
eeprom
- eeprom在51中的读写c代码，已测试通过，可以直接下载使用-eeprom read and write in 51 of the c code, have been tested, you can directly download
rxremote
- this program is very useful for many people
L3G4200D_SPI_FOR_Arduino
- 本程序基于Arduino UNO开发，代码通过SPI接口读取L3G4200D陀螺仪的Y轴角速率-This program is based on Arduino UNO. This program read Y-axis rate L3G4200D Gyro through SPI interface.
adc12
- 基于MSP430的adc的运用，通过c语言编程，控制adc芯片的采样-C programming language based on the use of the MSP430 ADC control the ADC chip sampling
AVR_Path-_Finder_Robot
- Line follower is an autonomous robot which follows either black line in white are or white line in black area. Robot must be able to detect particular line and keep following it. For special situations such as cross overs where robot can have m
fifo89
- 读写FIFO的代码。此FIFO的长度为8，宽度为9，并且有基本的读写抑制功能。-the code of reading and writing FIFO. it has 8 length and 9 width.