资源列表
SDRAM
- 网上下载的一篇关于TQ2440的SDRAM的文章，写的不错，跟大家分享一下，也要感谢原作者-A good article about SDRAM of TQ2440, downloaded from the internet. And thanks to the original author.
HYG1926419C-YF62L-VA
- 此为华远显示192*64LCD驱动程序，该程序也适用于带SBN0064G控制器的LCD -This is the Huayuan display 192* 64LCD Driver program, which also applies to the LCD controller with SBN0064G
freescale_SAEJ1939
- freescale 的can实验，用的是扩展模式，演示了saej1939协议-the freescale the can experiment with is to extend the mode of presentation saej1939 agreement
KINGVIEW
- 专门介绍KingView（组态王）的一本书籍，其实象组态王和wincc这些软件关键是入门，赶快上手，然后就慢慢做项目，积累经验。这本就是快速入门的钥匙。
RTOS_Mindows4.10
- Mindows 4.10可提供多种操作系统功能，是实时抢占式操作系统，任务支持多种优先级抢占调度，将实时性高的任务设置为高优先级就可以保证软件系统的实时性，用户也可根据自身需求选取需要的部分，也可在此基础上编写代码增加自己需要的功能，具有可裁剪性。-Mindows provides a variety of operating system, real-time preemptive operating system, task support multiple priority preempt
uart
- fpga 串行口 接收和发送程序，采用verilong语言编写-fpga uart ，receive and send include writed by verilog language
LCDd
- S3C2410下LCD驱动程序移植 及GUI程序编写-S3C2410 transplanted under the LCD driver and GUI programming
os20
- This release of OS/20 is for use with both the OS-link based toolset, (ST20-SWC, release 2.0, on both Sun and PC platforms) and DCU based toolset (Osprey, release 2.0).
An_j1939
- Controller area network
STM32-IIC
- stm32iicio口模拟程序，非硬件的，可以借鉴，但是个人推荐还是用硬件好！-stm32iicio port simulation program, non-hardware, you can learn, but good personal recommendation or hardware!
Baxis_gyroscope__IDG300_source
- 二轴陀螺仪IDG300源程序，主要实现姿态实现算法和温度补偿及校准,B-axis gyroscope IDG300 source, the main algorithm realize realize posture and temperature compensation and calibration
wendu
- 温度+电压采集 使用的是LPC2132芯片-Temperature+ voltage acquisition using the LPC2132 chip