资源列表
t2
- 利用51系列单片机设计一个24小时制电子时钟，电子时钟的时、分、秒数值分别通过P0、P1、P2端口输出（以压缩BCD码的形式）。P3.0为低电平时开始计时，为高电平时停止计时-Use of 51 series microcontroller design a 24 hour system electronic clock, electronic clock, points, second respectively through numerical P0, P1, P2 port output
text
- 设有8bits符号数X存于外部RAM单元，按以下方式计算后的结果Y也存于外部RAM单元，请按要求编写程序。 -With 8 bits symbol number X stored in external RAM unit, according to the following way calculated results Y also exist in external RAM unit, please write a program as required.
16
- 编写两个十六位数的加法程序。 有两个十六位无符号数，分别存放在从20H和30H开始的数据区中，低八位先存，高八位在后，和存于R3（高八位）和R4（低八位），进位位存于R2。-Write two sixteen digits addition program. There are two 16 bit unsigned number, respectively in from 20 h and 30 h began to data area, low eight put first, hi
fill
- 数据块填充程序：将片外RAM 7000H-70FFH单元按一定规律填充-Data block filling procedure: piece of external RAM 7000 h- 70 FFH unit according to certain rule filling
EZ-USB_TRM2
- Cypress Technical Reference Manual
Bulkloop
- Cypress Bulkloop firmware
scd_v2_3_4_r_02_05_2011(2)
- EMV COMMUNICATION PROTOCOL
USB-mouse
- 基于usb2.0接口编写的鼠标程序 usb通讯-Usb2.0 interface written in the mouse program usb communication
ade7878
- 实现数字芯片ADE7878的SPI完美驱动，驱动MCU采用的是ARM7系列的stm32芯片。-To realize digital chip ADE7878 of SPI perfect drive, drive the ARM7 MCU is series of stm32 chip.
gggggg
- 郭天祥单片机视频课后习题答案(全)用C语言编写的-The 郭天祥 single-chip video Homework answers (full) C language
Keil-uVision2
- kill的使用及与单片机之间的程序仿真，希望对大家有用-use of kill and simulation, with the program between the microcontroller and the hope that useful
ARM-LC
- ARM裸机开发程序里面提供了使用ADS开发环境下的，在MINI2440开发板上的驱动程序包含了ADC,IIC,LCD，触摸屏等驱动可以为初学者打下基础.-ARM bare metal development program which provides ADS development environment MINI2440 development board driver contains the ADC, IIC, LCD, touch screen, the driver can lay