资源列表
pwm2
- STM32在IAR环境下操作定时器用比较模式输出PWM波形。-STM32 timer with compare modes, the output PWM waveform operating in the IAR environment.
pwm1
- STM32在IAR环境下操作定时器输出互补模式的PWM的程序源码。-STM32 mode PWM operation timer output complement each other in the IAR environment program source code.
Tq02
- 这是一个生产流水线上Mobi识别嵌入系统，关键是采用了CAN BUS作为通讯协议。-This is the Mobi recognition embedded systems on a production line, the key is to use the CAN BUS as a communications protocol.
hongwaijiema
- 好使的红外解码程序，红外接收为SM00038。-So that the infrared decoding process, the infrared receiver is SM00038.
IC-card-elementary-knowledge
- 接触式，非接触式ic卡的基本知识，主要应用以及市场和开发。-Contact, basic knowledge of the non-contact ic card, main applications and market and development.
IC-card--IFD
- 主要介绍接触式ic卡的接口设备IFD的协议，7816协议及读写时序的编程。-Introduces contactless ic card interface device IFD protocol, the programming of the 7816 agreement and to read and write timing.
M4
- TI M4系列 MCU官方例程，完全搭配其demo板，程序稍作改动即可和自身项目无缝连接，物超所值-TI M4 MCU official demo project, complete with its demo Circuit board, procedures are changed slightly and their project seamless connection, it s valuable for your development
SDCARD
- stm32 SDIO 操作的寄存器版本，是根据库函数版本改的，不支持多块写入，貌似是库函数原有的bug，暂时没法解决。使用时依次调用SD_Init()，SD_GetCardInfo(&SDCardInfo)，SD_SelectDeselect((u32) (SDCardInfo.RCA << 16))，SD_EnableWideBusOperation(SDIO_BusWide_4b)，然后就可以调用扇区读写操作了。-the stm32 SDIO operation of the r
51stepmotorP1602
- 基于51单片机+步进电机+1602lcd的步进电机驱动程序，按键说明见包内说明-Based on 51 single-chip+ stepper motor+1602lcd, stepper motor drivers, buttons to see the package descr iption
12864-18B20
- 基于51单片机+lcd12864+18b20的温度计程序，-Based on 51 single-chip+lcd12864+18b20 thermometer procedures,
1602P18B20clock
- 基于51单片机的电子钟，带温度及闹铃功能，注意使用ds1302时钟芯片、1602液晶及18b20温感-51 microcontroller-based electronic clock with temperature and alarm functions, pay attention to use ds1302 clock chip, 1602 and 18b20 temperature sense
51trafficlight
- 基于51单片机的交通灯程序，用keil uv3编的-51 microcontroller-based traffic lights program, use keil uv3 Code