资源列表
super-mary
- 基于LABVIEW的一款MARY小游戏，游戏功能比较简单，但基本的跳跃，移动及躲避怪物功能齐全。可作为LABVIEW爱好者关于外设输入采集方面做些参考。-MARY of a LABVIEW-based game, the game features relatively simple, but the basic jump, full-featured mobile and avoid monsters. As lovers on the peripheral input capture LAB
7X256develpmentboard
- AT91SAM7X256开发板原理图，PHY芯片为RTL8201,有串口，板上有SD卡接口，有SPI的FLASH和I2C的E2PROM-AT91SAM7X256 development board schematics, PHY chip RTL8201, a serial port, a SD card interface board, with SPI, I2C FLASH and the E2PROM
CAN
- lpc1114基础教学例程，为刚接触的人提供便利-the lpc1114 basis for teaching routine for people new to facilitate
libmodbus-2.0.3.tar
- Modbus TCP Master/Slave communication library. Must be compiled with gcc compiler.
C8051F
- C8051F的例程。包括AD、DA、比较器的编程、CAN总线等。还有单片机的应用实例-C8051F routine. Including AD, DA, comparator programming, CAN bus, and so on. There SCM Applications
mcp2515
- mcp2515 CAN Driver for Atmega128 MCU
C67xDSPLIB_v200
- 6713库文件，包括算法实现，安装后使用-6713 database files, including algorithms, using installed
hurray
- 这是IEEE802.15.4协议在tinyos下的实现。硬件平台是MICAz微尘，使用的是nesC语言。-This is the IEEE802.15.4 protocol implementation under the tinyos. Hardware platform is MICAz dust, using the nesC language.
Lpc1788_ucGui
- 本工程用于LPC1788外加AT070TN83，外接SDRAM作显存，ucGui移植完成(其实也不是移植，也就修改了几个地方，第一次用还是有点麻烦的，以前没用过ucGui) 本文件夹中另有一个GuiLib这个工程是用于生成ucGui.lib库文件，如果直接将ucGui源文件加入到你的工程文件中那个编译时间真让人受不了，ucGui的编译差不多要2分钟，如果要修改ucGui的东西，请修改后再重新编译一下。 显例程显示的是dialog_all.c的对话框，网上下载的例子-LPC1788 ucG
waveproducer
- 波形发生器 三角波 矩形波 正弦波 基于multisim设计-Waveform generator sine wave square wave triangle wave Design based on multisim
UART_Program
- 串口中断服务函数集，使用十分方便 51单片机串口调试程序(C语言)-Serial port interrupt service function is set, 51 MCU serial port is very convenient to use the debugger (C language)
ef150
- an rfid reader that consist schematic and code for an a25khz rfid reader with attiny2313