资源列表
CC2530KEY
- 基于ZigBee的CC2530按键扫描实验源代码-CC2530 ZigBee-based source code for key scan experiment
CLOCK
- 数电课程设计报告——《数字钟的设计》，包含报告、目录、原理图（dwg格式）-Number of electrical curriculum design- the " digital clock design" , including reports, directories, schematic (dwg format)
ScmLight
- 简单的单片机入门程序，流水灯从两侧流动亮到中间，适合入门者学习-Simple single-chip entry procedures, light from both sides of the flow of water to the middle light, suitable for beginners to learn
BB_xM_Gerbers_REV_A3
- DM3730作为核心处理器的COtexA8 核心板原理图，已经有经过验证-the Schdoc for the core of DM3730 TI
Keil-C51-uVision4
- Keil uVision4的使用入门，中文内容，快速上手-Keil uVision4 getting started, Chinese content, Quick Start
设计单片机-485-PC串口通信
- 自我设计单片机-485-PC串口通信，包括虚拟串口、串口调试器、串口调试器及仿真源代码-Self-designed microcontroller-485-PC serial communication, including virtual serial port, serial port debugger, serial debugger, source code and simulation
简易低频信号源的设计
- 简易低频信号源的设计，简易低频信号源的设计，供大家参考，一起学习-Simple design of low-frequency signal source, the design of simple low-frequency signal source, for reference, learning together
canbus
- 实现CAN总线的通信，并通过测试验证，用verilog在FPGA上实现-CAN bus communication, and tested to verify that, in the FPGA using verilog
io_driver
- 1602 lcd 显示驱动 与按键监测 控制口 rs=P0^7 rw=P3^3 sbit ep=0xc4 数据接口 P2 24M时钟 显示范围为 0~9 A~Z a~z : - / < > . 按键 P1 共计16个按键键值1~16 返回0表示无键入 -1602 lcd display driver with key monitoring and control port rs = P0 ^ 7 rw = P3 ^ 3 sbit ep = 0x
PIC18_USART1_Demo
- PIC18F85J11 单片机通信程序,主要应用于RS232、RS485通信。-PIC18F Micro Control Unit communication program。User RS232、RS485 communication。
STM32 USB复合设备(虚拟两个串口)
- 2、STM32 USB复合设备(虚拟两个串口)-2, STM32 USB composite device (virtual two serial ports)
阻塞模式主要用于无窗口、多线程处理中
- 阻塞模式主要用于无窗口、多线程处理中。启动服务之后应该启动一个线程来轮询DTU数据，收到数据后直接处理，或放数据缓存，再由其他线程来处理。-Blocking mode is mainly used for non-window, multi-threaded processing. After the start the service should start a thread to poll the DTU data, received data directly, or put the d