资源列表
LED-MOVING-DISPLAY-SMALL
- This the led moving display with small number of character.-This is the led moving display with small number of character.
LED-MOVING-DISPLAY-LARGE
- This the program for the led moving display using shift registers.-This is the program for the led moving display using shift registers.
ph_1wire_1
- This circuit diagram for PH meter.-This is circuit diagram for PH meter.
PH-TEMPERATURE-COMPENSATION
- This important document for PH calibration and details regarding PH temperature compensation.-This is important document for PH calibration and details regarding PH temperature compensation.
EEPROM-16-Bit-Test
- 16 Bit Eeprom Read. Can be used with AVR, PIC, and any microcontroller.
uip_ftp
- 基于uip9.0的tcp ip ftp全套源码
xTimer-with-4094
- goo source of reference
17zhongdianzishejichengxu
- 17种电子设计实用小软件，爱好电子爱好单片机的同志们看看吧！-17 kinds of practical small electronic design software, hobby electronics hobby microcontroller comrades see it!
2410_LCD
- 使用2410芯片开发的时钟程序，裸机开发，支持触屏调整时间，加速减速，带有背景图，有数字式显示和表盘显示。-Using the 2410 chip clock development program, system development, support for touch screen to adjust the time, acceleration and deceleration, with a background image, a display digital display an
msp430g2xx3_uscib0_i2c_01
- I2C接口TMP100温度传感器在9位模式。 计时器一CCR0中断用于醒来,读这两个字节的 TMP100的温度寄存器每62毫秒。如果温度大于28 c,p1 0设置,否则复位。在LPM0 CPU操作。 速度~ 100 khz I2C。-I2C interface to TMP100 temperature sensor in 9-bit mode. Timer_A CCR0 interrupt is used to wake up and read the two bytes of
msp430g2xx3_wdt_01
- 使用软件定时切换p1 0由WDT ISR。切换率 大约30 ms基于违约DCO / SMCLK时钟源 在本示例中使用的WDT。- Toggle P1.0 using software timed by the WDT ISR. Toggle rate is approximately 30ms based on default DCO/SMCLK clock source used in this example for the WDT.
msp430g2xx3_ta_uart2400
- 使用定时器一CCR0硬件输出模式和SCCI数据锁 实现UART函数@ 2400波特。软件不能直接读取和 写信给RX和TX别针,相反正确使用输出模式和SCCI数据锁了。使用这些硬件特性消除了ISR 延迟效应作为硬件确保输出和输入位自锁和时机是完美的同步与定时器一个不管其他软件活动。 -Use Timer_A CCR0 hardware output modes and SCCI data latch to implement UART function @ 2400 baud