资源列表
F0_software
- honeygeek的教程，射频通信，没有用到zigbee协议栈，是点对点通信，运行在cc2530-honeygeek tutorials, RF communications, did not use the zigbee protocol stack is point to point communication, running on cc2530
JLX240-003-9341-8P2
- 基于51单片机的TFT液晶驱动程8080时序,8位并口，信号ILI9341，可以直接移植，-Based on 51 single-chip TFT LCD driver 8080 Timing, 8-bit parallel signal ILI9341, can be directly transplanted,
12864LCD
- 基于MSP430F5438A的12864的液晶程序-Based on MSP430F5438A 12864 LCD procedures
LED
- 基于msp430F5438A LED的显示-Based on msp430F5438A LED display
DCP-202-Digital-tube-display
- 基于MSP430F5438A的数码管显示-Based on MSP430F5438A digital tube display and keyboard circuit
TIME_A
- 基于MSP430F5438A 定时器程序-Based on the MSP430F5438A timer program
51-TFT-LCD
- 用51单片机对2.4寸TFT-LCD彩色液晶进行控制-With 51 pairs of 2.4-inch TFT-LCD color LCD control
LCD-SMS0801BPAD-Display
- 长沙太阳人电子公司SMS0810B液晶模块驱动程序。用430内部AD采数据，用SMS0810B液晶显示出来。-Changsha Sunman Electronics SMS0810B LCD driver. With 430 internal AD sample data, used SMS0810B LCD out.
CC2530-14
- 物联网2530在PC用串口控制LED，串口发命令10#，11#，20#，21#控制LED-IOT 2530 on the PC with a serial control LED, serial send commands 10#, 11#, 20#, 21# control LED
CC2530-8
- 物联网2530定时器中断，红灯常灭，1000次中断，让绿灯闪烁-IOT 2530 timer interrupt, the red light is off, the 1000 interrupt, so the green light flashes
CC2530-9
- 网联网2530外部中断，每按下OK,CANCEL（外部中断）键改变绿灯状态.-Network interconnection 2530 external interrupts, each press OK, CANCEL (external interrupt) key to change the green state.
CC2530-6
- 网联网2530的T3的使用，红灯亮，绿灯闪烁.-2530 T3 network interconnection use of red light, green light flashes.