资源列表
Desktop
- 永磁同步电机调速系统，采用模糊PI进行速度控制，常规PI进行电流控制-Permanent magnet synchronous motor speed control system, using fuzzy PI speed control, the conventional PI current control
the-problem-of-eight-queens
- 用遗传算法解决8皇后问题，并在VC++环境下调试通过，得出了正确结果，word文档说明和C源代码-With a genetic algorithm to solve 8 queens problem, and in the VC++ debugging environment through, come to the right result, word and the C source code documentation
对具有随机噪声的二阶系统的模型辨识
- matlab在系统辨识中的应用此处为对具有随机噪声的二阶系统的应用的源代码及运行后结果（包括图像）-Matlab system identification in the application is right here for the second random noise of the system source code and running after the results (including images)
u-law-CCDF-N=128
- 程序仿真得图为原信号与u律压扩信号的互补累积函数曲线图。仿真参数：子载波N=128，采用QPSK调制。-The photo shows the original simulation program was u-law signal and the signal of the complementary cumulative function expansion curve. Simulation parameters: sub-carriers N = 128, using QPSK modu
matlabpicMRF
- 一个马尔可夫（MRF）图像分割MATLAB的源码,有30几个函数。Markov随机场的例子程序,对于初学入门MRF的人很有用,能得到直观的印象。-A Markov (MRF) image segmentation MATLAB source code, 30 a few functions. Markov random sample program, for beginners who are useful entry-MRF can get a visual impression.
CRC 校验源码分析
- CRC-16校验源程序及算法分析-CRC-16 checksum algorithm analysis and source
222222222222
- 1． 利用克鲁斯卡尔算法求网的最小生成树。 2． 利用普里姆算法求网的最小生成树。 3． 要求输出各条边及它们的权值。 -1. Using Kruskal' s algorithm for minimum spanning tree network. 2. Prim algorithm for the use of the minimum spanning tree network. 3. Requirements of the output of each side, and
roundCenter
- vc2008 dos 程序 已知AB两点坐标，半径R。 求2个圆心。 公式使用MATLAb推导的，做了一点简化，和小的改动。 都在函数 double jisuanYanxin(double Ax,double Ay,double Bx,double By,double R) 里面-vc2008 dos program known AB two coordinates, radius R. Seeking two center of the circle. Formula de
sscomunication1
- 扩频通信 仿真的matlab源代码，仅供参考-Spread spectrum communication matlab simulation source code, for reference only
Tensile-Strength
- 灰色预测模型的MATLAB源程序,包括单输入和多输入的情况。-Gray prediction model MATLAB source.
ErrFun
- 求误差函数的值（算法借鉴MATLAB中erf函数）-According the erf function in matlab program, get the value of ERROR function.
pufenxi
- 结构动力学谱分析程序，对搞结构动力学的同学有帮助-very good