资源列表
2-dwt
- 利用matlab实现二维离散小波变换的源代码，并比较不同小波下的图像数据统计参数，同时比较小波变换后不同边缘延拓方法下的能量分布特点-Matlab to achieve the two-dimensional discrete wavelet transform source code, and compare different wavelet image data statistical parameters Compare wavelet transform edge extension
DFIG_control
- 这是双馈电机空载情况下，转子侧变流器的控制电路。-This is a doubly-fed machine no-load cases, the rotor side converter control circuit.
matlab-simulink双馈风机的仿真模型
- matlab-simulink双馈风机的仿真模型-matlab-simulink DFIG simulation model
power_wind_dfig1
- 本例题是在MATLAB环境下搭建双馈风力发电机的模型，通过解耦控制实现功率的控制。-The sample questions are in the MATLAB environment to build double-fed wind turbine model, through the decoupling control to achieve power control.
final
- 本程序设计了一个最佳升余弦滚降系统，包括输入输出信号的波形、功率谱、眼图和系统误码率曲线-This procedure is designed or one of the best cosine roll-off system, including input and output signal waveform, power spectrum, eye diagram and BER curves
LRA
- Lattice reduction mimo detection
cordic_atan
- CORDIC arctangent(atan) Simulink model. You can generate HDL from this model
lms
- 使用LMS算法进行预测的Matlab源代码 使用时只需改变载入文件名 调整L和delay就可以了-Using the LMS algorithm to predict the use of Matlab source code file name when you only need to change the load L and the delay can be adjusted in
control_system
- 该系统是双馈发电机转子侧的变流器控制电路，虽然不是很完善，有一定得参考价值。-The system is doubly-fed generator rotor side converter control circuit, although not perfect, there must be reference value.
lsyqc
- 现代谱估计的matlab的程序。用的是最小二乘法。-Modern Spectral Estimation matlab procedures. Using a least squares method.
attachments
- The work presented in this thesis includes control system design, analysis and grid synchronization of a DFIG (doubly-fed induction generator) driven by a wind turbine using stator-voltage and stator-flux oriented frames. The DFIG is a special type o
cyclo.paper
- An Introduction to Cyclostationary Noise by Joel Phillips and Ken Kundert