1 操作说明：

　　根据提示输入三位编码（编码不大于255），可以按N键删除编码，按Y键确认，再按UP键为上行，按DOWN键为下行，按S键，为停止。再次按N键为删除编码，可重新输入其它编码进行其它灯的控制。



　　注：仿真中显示画面是倒着的。



2 用途：

此遥控器用来作智能升降机遥控升降用，当然也可以改成其它用途，整机用锂电池供电，采用专用的无线收发模块，显示用12864点阵液晶显示。有效控制距离，50m左右，欢迎大家欣赏！



3 打开仿真文件，直接运行即可看到显示画面。本仿真软件用的是protues7.5版本的。-1 Instructions:

According prompted three encoding (encoding is not greater than 255), you can press N key to delete the code, press Y button to confirm, then press UP key for uplink, press DOWN key is down, press S key to stop. Press N key again to remove code, may re-enter the other codes for other lighting control.



Note: The simulation of the display is backwards.



Two purposes:

　 The remote control is used to make intelligent lifts with the remote control lifting, of course, can also be changed to other uses, lithium battery-powered machine, using a dedicated wireless transceiver modules, dot-matrix LCD display with 12864. Effective control of the distance, 50m or so, welcome everyone to enjoy!



3 Open the simulation file, you can see the direct operation display. The simulation software is used in protues7.5 version.