说明：

　GR(M)-87目前只能应用于WINCE5.0版本中，其它版本用不了。


1.该软件是用来检测GPS的COM以及GPS信号的软件，应用广泛

2.mGpsCmd是PPC(WINCE系统)用的，GpsViewer 1.5是PC和PPC的安装程序，考到SD卡上就可以直接用！

用法1：搜索COM口，连上GPS，点SCAN，如果提示找到FOUNDGPS，那么就是对应的COM口





3..在WINDOWS XP/2000系统使用，安装USB_driver -V2.1.0.exe 驱动程序，串口也通用。

4.安装GpsViewer 1.5.exe。安装完后，打开进入界面，COM Port 不用选择，会自动扫描，见GPS1的图片；Baudrate：4800.
　然后按Scan...进行扫描到串口后，再按Open GPS,即可会自动找到卫星，从图上或下面的显示可以看到。见GPS2图片。

5.GPS天线必须放在室外才有效。

6.GpsViewer， mGpsCmd软件不会自动刷新，请一会按下最小化，一会再点弹出来，手动刷新。
　 ,Descr iption:

　 GR (M)-87 are currently only applies to WINCE5.0 version, other versions of few.


1. The software is used to detect the GPS signal COM and GPS software, a wide range of applications

2.mGpsCmd are PPC (WINCE system) used, GpsViewer 1.5 is a PC and PPC installation procedures, test the SD card can be used directly!

Usage 1: Search COM port, even on the GPS, point SCAN, if prompted to find FOUNDGPS, so is the corresponding COM port





3 .. WINDOWS XP/2000 systems in use, the installation USB_driver-V2.1.0.exe driver, serial port is also common.

4. Installation GpsViewer 1.5.exe. After installation, open access to the interface, COM Port do not have choice, will automatically scan, GPS1 see the picture　Baudrate: 4800.
　 Then press Scan ... after the scan to the serial port, and then Open GPS, you will automatically find the satellites, or from the map display can be seen below. GPS2 see picture.

Outdoor antenna must be placed on 5.GPS