搜索资源列表
inver_power
- 本逆变电源要求能将12V电瓶的直流电源通过该逆变器逆变后，能产生110V 50HZ或60HZ的交流电压，并且能在150W的负载范围内，保证其输出电压稳定在110V±5 的范围内-Requirements of the inverter can supply 12V DC battery through the inverter after the inverter, to produce 110V 50HZ or 60HZ AC voltage, and load in the range 15
MY_XSENS_CODE
- 这是我自己写的xsen的mti系统程序，从陀螺仪和加速度计中实时读取数据，并在地理坐标系中进行解算，最后积分得到速度和位置信息。可以用于手势识别或者精度要求不高的导航系统。如果要用于精确导航，则应该进一步进行修正。程序使用com4进行通信，波特率是115200，采样频率是50hz，这些参数都可以修改。-This is my own writing xsen the mti system program from the gyroscopes and accelerometers to read
OV7660SettingV1.0
- Overview Input Clock = 24Mhz Preview VGA 15fps @ 60Hz VGA 12.5fps @ 50Hz Capture VGA 15fps @ 60Hz VGA 12.5fps @ 50Hz Output Format YCbCr 4:2:2 (ITU 656) YCbCr to RGB conversion R = Y + (351*(Cr – 128)) >> 8 G = Y – (179*(Cr –
BUTTWATH
- 使用MATLAB自带的函数，实现了50Hz带阻滤波器，其中的参数可以修改，即可以实现任意频率的陷波器。-Achieved a 50Hz notch filter
50_60HZ
- 一个50HZ与60HZ的交流频率波形模拟发生器-A 50HZ and 60HZ exchange frequency analog waveform generator
tppfc
- matlab simulink 三相PFC仿真，input为50hz交流，output为直流。闭环矢量控制-matlab simulink three-phase PFC simulation, input for 50hz exchange, output for the DC. Closed-loop vector control
NB
- 一个逆变的控制程序，50HZ输出，波形很稳定-An inverter control procedures, 50HZ output waveform is very stable
key
- 键扫描 处理程序 verilog 使用时钟为50Hz // 低电平为按下,高电平为断开 // 输出状态,1为键入,0为无键-Key scanning process using the clock for Verilog 50Hz// low level for the press, high for the disconnect// output state, one for the type, 0 for no key
pic12c508_lamp
- 使用PIC12C508单片机，内部4MHZ时钟，4脚输入50HZ脉冲信号，7，6，3脚（GP0，GP1，GP4端口）为输出口。其中渐变部分是让灯慢慢的变亮（或灭）。-Using PIC12C508 microcontroller, the internal 4MHz clock, 4 feet 50HZ input pulse signal, 7,6,3-pin (GP0, GP1, GP4 port) for the output. Part one of gradual change is
DASQUARE
- TMS320LF2407产生频率为50HZ的方波源码-TMS320LF2407 generated square-wave source
DA_618
- TMS320LF2407产生频率为50HZ的锯齿波源码-TMS320LF2407 generate the sawtooth frequency is 50HZ source
sanjiao
- TMS320LF2407产生频率为50HZ的三角波源码-TMS320LF2407 produce a frequency of 50HZ triangular wave source
sinwave2
- TMS320LF2407产生频率为50HZ的正弦波源码-TMS320LF2407 generate the sine wave frequency is 50HZ source
pwm
- 变频输出！按p3.2连续输出50hz,1KHZ,1KHZ窄脉冲， 停止。输出口P3.3。-Frequency output! P3.2 by continuous output 50hz, 1KHZ, 1KHZ narrow pulse, and stop. Output port P3.3.
FFT
- fft时间抽样仿真的C程序，对50Hz的正弦信号进行抽样，用FFT程序进行谱分析-fft time sampling simulation program
A3DFX_090609set
- 三星sensor A3D 摄像头调试优化代码 (24MHz, 50Hz, 15-8fps, CrCb)-Samsung camera sensor A3D debugging optimized code (24MHz, 50Hz, 15-8fps, CrCb)
PCCLKLED
- 编写程序，使实验台上的LED显示时钟的分和秒，1s的定时由8253输出50HZ的方波申请中断50次来完成。-Preparation procedure, so that the experimental stage of the LED display clock minutes, and seconds, 1s timing 50HZ output by 8253 to apply the square wave to complete interruption of 50.
50Hztrapper
- 一个数字陷波程序，已调试通过。用于滤除50hz的工频干扰。-A digital notch procedures through debugging. Used to filter out the 50hz frequency interference.
interrupt
- 用arm实现中断,已完成各向功能，实现输出50hz方波-the code of interrupt code