搜索资源列表
oscillator
- 正弦波振荡产生电路,个人认为相当不错的资料，来源于网络
数字钟的设计
- 数字式计时器一般都由震荡器，分频器，译码器及显示几部分组成。其中震荡器和分频器组成标准秒信号发生器，接成各种不同进制的计数器组成计时系统，译码器，显示器组成显示系统，另外一些组合电路组成校时调节系统。-digital timer usually are oscillator, dividers, decoder and display several parts. Which oscillator and divider standard component signal generator s
ledtest
- 用于测试ACEX1k30的流水灯程序，晶振频率为20mhz。运行环境Maxplus2-for testing the water ACEX1k30 lights procedures, the frequency of 20MHz crystal oscillator. Operating environment FLEX10K
天线阵
- 对均匀直线阵、半波振子进行各种方向图综合,用music算法进行的DOA估计，详见说明-right uniform linear array, half-wave oscillator for integrated map in all directions, with music algorithm for the DOA estimates, as detailed in Note
osc
- Oscillator Switching Demonstration for the PIC18CXXX
oscillator
- 音效卡频谱分析，示波器，带有很多的使用功能，能实时捕捉和显示震幅很小的波形-Sound card spectrum analyzer, oscilloscope, with the use of many functions in real-time capture and display a small amplitude waveform
DS3231_Driver 高精度实时时钟芯片的驱动程序
- 高精度实时时钟芯片的驱动程序，采用I2C方式，包含.H和.C文件并由详细注释。-extremely accurate I2C real- time clock (RTC) with an integrated temperature-compensated crystal oscillator (TCXO) and crystal。the rar includ .H和.Cfile。
boot.rar
- SL-MEGA8开发板实验，自引导IAP实验。 注意： 1、使用外部晶振、实时时钟晶振时，数码管的DP、G段和PB7、PB6的连接应该断开， 而使用内部RC振荡时，数码管的DP、G段和PB7、PB6的连接可以连接。 2、使用外部时钟，数码管的G段和PB6的连接应该断开。,SL-MEGA8 development board experiment, since the IAP to guide experiments. Note: 1, the use of an ext
HS1101
- HS1101与555振荡电路构成湿度测量电路-HS1101 oscillator circuits with 555 circuit humidity measurement
nco
- A numerically-controlled oscillator (NCO) is a digital signal generator which creates a synchronous (i.e. clocked), discrete-time, discrete-valued representation of a waveform, usually sinusoidal.
(EWB)设计的频率为200Hz的振荡器
- 使用Electronics Workbench 5.0电子仿真软件(EWB)设计的频率为200Hz的振荡器。-Using electronic simulation software Electronics Workbench 5.0 (EWB) design an oscillator whose frequency is 200Hz.
fuzhipu
- 绘画Duffing振子的幅值谱即频率—幅值特性图。-Painting Duffing oscillator amplitude spectrum that frequency- amplitude characteristics of Fig.
Sources
- 采用DS18B20和STM32F103RBT6编写的测温程序，每秒从USART1输出温度数据。采用3.5版固件库，自编DS18B20库文件，需要注意的是使用本库前需要写delay_us和delay_ms函数。电路上采用8M晶振，PA8为数据口，如有变化请修改stm32f10x_conf.h文件。-The temperature program DS18B20 and STM32F103RBT6-written per second from USART1 output temperature d
mcu
- 本设计的是一个基于单片机AT89S52的出租车自动计费设计,附有复位电路,时钟电路,键盘电路等。复位电路是单片机的初始化操作,除了正常的初始化外,为摆脱困境,通过复位电路可以重新开始。时钟电路采用12MHz的晶振,作为系统的时钟源,具有较高的准确性-The design is based on a monolithic integrated circuit AT89S52 taxi billing design, with reset circuit, clocking circuit, key
at90can128-canbus.rar
- 不可多得的atmel公司canbus通讯程序（at90can128），经过二个多星期才完全调试成功。使用内部晶振8M，波特率＝500K。 结点2负责发送，结点1负责接收，同时结点1将收到的数据通过串口上传到PC机。,Rare CANBUS communication procedures Atmel Corporation [at90can128], after more than two weeks before full debugging success. Using interna
AVR_frequence.rar
- 此程序为一完整频率测量显示程序,所测频率较高(2MHZ),使用4兆晶振,程序兼有启动看门狗及对其管理功能.,This procedure is a complete frequency measurements show that the procedure, the measured high frequency (2MHZ), the use of 4 trillion oscillator, watchdog restart both procedures and their manage
This VHDL code pertains to the DCO model
- code.doc C.1 DCO LEVEL 2 This VHDL code pertains to the DCO model descr iption in Section 6.5.5. The entity declaration of the level 2 DCO is between lines 18 and 39. The VHDL generics or elaboration-phase parameter constants are declared between
Pelican 源码
- Pelican.txt ; Authors ; Date 10/3/2009 ; Device PIC16F84 ; Oscillator XT (4MHZ) ; Watchdog Disabled ; Function Simulates Pelican Crossing ; Bit config RB0 as an input, the rest of PORTB as outputs (0BRAGrgI) ; --------- Sub-Routines Fu
freqmeter
- PSoC 代码样例，高精度频率计。 详细内容见英文说明readme.txt-PSoC code sample: Precision Frequency Meter. A high precision frequency meter. Using the hourly time signal broadcast over the public radio station, the local reference oscillator is accurately calibrated.
AD7705(C51)
- 1，初始化： 如果AD7705复位引脚直连VCC，最好在初始化程序中加入初始化序列，不然ready信号不会输出。 2，输入范围 如果AD7705采集单端信号，则输入必须在0到VDD之间，而不可以超出或为负，如果一个输入为负，则另一个输入会有灌入电流的现象，芯片无法正常运行。-AD7705 is a complete 16-bit A ö D converter. Within Structure in Figure 1. If the external crysta