搜索资源列表
MIMO44
- 论文仿真原型程序,仿真四种（ZF,ZF-SIC,MMSE -SIC） Vblast接收的检测性能，绘制误比特率～信噪比曲线。 发端初始化=============================================================== 发射天线数tx,接收天线数rx,发射矩阵长度L(帧长) - Paper prototype simulation procedures, simulation of four (ZF, ZF-SIC, MMSE, M
Simple_TOA
- This a simple position location algorithm using Least Square Estimation algorithm. Timing information is time of flight (TOA) of signal between Tx and Rx. This code generally describes the Positioning method, Also it plots final coordinate of node in
SingleCellofdm
- OFDM链路级的仿真器场景是单小区单用户，信号从发送端发送，在接收端进行信号估计。估计误差可以从接收和发送信号的不同得到。仿真器的输出是BLER/BER vs SNR。-OFDM Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx si
QPSK_chain
- Simulation of a baseband QPSK mod/demod: TX : a pseudo random bit stream generation, Serial to parallel conversion, QPSK Mapping (Gray coding), Signal power computation Channel : AWGN channel RX: Soft Demapping / Hard Demapping, Plot constellat
ofdm_webexample
- An example of OFDM modulation implemented in MATLAB with simulations for tx, rx.
Pro
- vblastpic1:tx=2,rx=2时ZF,ZF-SIC,MMSE -SICvblastpic2:tx=4,rx=4时ZF,ZF-SIC,MMSE -SIC vblastpic3 vblastpic4:MIMO vblastpic6:tx=4,rx=4, vblastpic7ZF-SIC(unordered) vblastpic8: vblastpic9: vblastpic10: vblastpic11:能 vblastpic12:tx=2,rx=2,M
stbc_22
- stbc for 2 tx and 2 rx
subimage
- Subimage.m is a MATLAB function that extracts a part of the image specified by its parameters. The image should be a binary image (e.g. not color image).Function elements: f-binary image m,n-dimension of extracted image rx,cy- starting point of
allmod2X2
- its a basic program to 2X2 antenna system design to implement tr and rx
WimaxPhyLayerSimulationCode
- Simulation PHY layer of Wimax 802.16e, including Tx, Channel and Rx, baseband only.
WiMAX802.16eSimulink
- Simulink simulation for PHY layer of Wimax 802.16e, baseband only, including Tx Channel and Rx.
2Tx-2Rx-Spatial-Multiplex
- 介绍了在MATAB中开发的MIMO通信系统的容量、误码率等问题。很适合初学MIMO的研究生或者科研人员-MATLAB simulation for MIMO capacity and BER
q6assign2final
- Simulation of Rayleigh fading channel : 2,4 & 8 Rx Antennas & BER calc
ofdm-Rx
- Matlab Code for OFDM Reciever
Link-a-System-Level-OFDM-Simulator
- 针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。-It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and
kalman
- 一连续平稳的随机信号x(t)，自相关函数RX(t)=e-/t/，信号x(t)为加性噪声所干扰，噪声是白噪声，测量值的离散值Z(k)为已知，TS=0.02s。 -3.2，-0.8，-14，-16，-17，-18，-3.3，-2.4， -18，-0.3，-0.4，-0.8，-19，-2.0，-1.2，-11，-14，-0.9，0.8，10，0.2，0.5，-0.5，2.4，-0.5，0.5，-13，0.5，10，-12，0.5，-0.6，-15，-0.7，15，0.5，-0.7，-2.0，-19
UWB BASEBAND ( TX RX Channel)
- This SYSTEM describes the IEEE 802.15.3a Multi-Band OFDM baseband detail algorithm and structure for both transmitter and receiver。 The following components will be addressed Signal detection Inner receiver architecture Outer receiver
Comm_system
- Communication channel + TX + RX design for picture transfer
rx-sm
- 发送端统一使用4根发送天线,通过改变接收天线的数目来比较不同数目的接收天线对空间调制（spatial modulation）系统性能的影响。-Sending uniform use of four transmission antennas, by changing the number of reception antennas to compare the different number of receiving antennas for spatial modulation (spati
HHFLinkQAM9L
- QAM9 signal transmission (RX/TX + BER calc)