搜索资源列表
JIEKOU
- 单片机与FPGA通信的小程序，做的不好请多指教。谢谢了！这真是个好网站啊-MCU and FPGA communications small programs, please do not enlighten. Thank you! This is a good site ah!
msp430与FPGA的通信
- 本程序实现的是MSP430与FPGA间的串并联合通行。
FPGA与USB通信的测试代码
- FPGA与USB通信的测试代码，包括FPGA中的程序（Verilog编写）和PC机上的主控程序以及USB固件程序。,FPGA and the USB communication test code, including the FPGA in the procedure [Verilog prepared] and PC-control procedures, as well as the USB firmware.
FPGA.rar
- 利用FPGA的51 IP核实现与单片机和ARM的串口通信,FPGA connect with MCU and ARM
mcu-fpga
- 单片机与fpga通信，单片机接受，可接受多位数据，该程序为单片机向fpga发送sclk信号，编译已通过-Communicate with the fpga chip microcontroller accepted and acceptable multi-bit data, the program for the microcontroller to send sclk signal fpga
stm32-and-fpga-communication-by-spi
- 该实验完成的功能是STM32与FPGA通信-The function of the experiment is STM32 and FPGA communication
频率接收
- STM32F103与FPGA的串口通信，波特率4800，采用单向通信的方法。(Serial communication between STM32F103 and FPGA)
EMIFA_FPGA
- 通过DSP的EMIFA接口 与FPGA 通信(Communicate with FPGA through EMIFA interface of DSP)
IIC_FPGA
- 通过DSP的IIC接口 与FPGA 通信(Communicate with fpga through IICinterface of DSP)
stm32开发板FSMC读写FPGA
- STM32通过fsmc总线与FPGA通信(stm32 communication with FPGA by FSMC bus)
pinlvji_32
- FPGA产生不同的频率值，STM32与FPGA通信，实现频率值的显示(Communicate with FPGA to realize the display of frequency value)
32FPGA低电平通信输出任意波形
- STM32和FPGA的通信，适用于STM32与FPGA的联调(STM32 and FPGA communication, for STM32 and FPGA of the joint)
5_FPGA实验指导书更新中
- stm32f4和FPGA通信，总线通信，串口通信，SPI和UART等FPGA代码和ARM代码及实验指导书(Stm32f4 and FPGA communications,such as bus communications, serial communication, SPI and UART. and FPGA code , ARM code and experimental instruction)
题目一单片机部分
- 单片机与fpga通过spi协议实现通信-单片机部分(SCM and FPGA through SPI protocol communication - SCM)
VB编写的仿真实电子琴操作界面
- VB编写的仿真实电子琴操作界面，包含与FPGA串口通信的功能(The virtual electronic instrument interface written by VB contains the functions of serial communication with FPGA)
STM32与FPGA通信
- stm32与fpga之间的通信，协议是SPI的，可双向通信（双向通信需要自己例化，只例化了fpga到stm32）(Communication between STM32 and FPGA, the protocol is SPI, two-way communication (two-way communication needs to be taken as an example, only FPGA to STM32))
STM32与FPGA通信程序
- STM32F1与FPGA的SPI通信程序(SPI communication program between STM32F1 and FPGA)
DSP+FPGA步进电机开发板资料
- DspMotor里是dsp步进驱动源码。环境 ccs3.3 ；.FpgaMotorControl是fpga光栅尺采集源码。环境 ISE10.1(DspMotor is the DSP stepping drive source. Environment CCS3.3;.FpgaMotorControl is the source of FPGA grating ruler. Environment ISE10.1)
中级篇03：UART，波特率115200与PC通信
- 本程序实现FPGA的串口通信功能，可以进行数字字符等的发送，波特率为115200(This program implements the serial communication function of the FPGA, and can transmit digital characters, etc., and the baud rate is 115200.)
程序-正弦信号发生器(FPGA+STM32版)
- 以FPGA为核心，实现正弦波、调制波AM、FM、ASK和PSK等功能，通过SPI协议与STM32通信，实现输出波形的选择、频率的设置和基带信号的设定等。(With FPGA as the core, the functions of sine wave, modulation wave AM.FM. ASK and PSK are realized. The output waveform selection, frequency setting and baseband signal sett