搜索资源列表
LPC2131串口（TX+RX）+TIME0+ADC采样的代码
- LPC2131串口（TX+RX）+TIME0+ADC采样的代码,采用中断方式编写，绝对经典！-LPC2131 (TX RX) TIME0 ADC sample code, using interrupt the preparation, absolute classic!
C8051F020实现ADC采样芯片外的模拟电压，通过LCD显示
- C8051F020实现ADC采样芯片外的模拟电压，通过LCD显示
STM32，ADC采样程序，TIM定时触发
- STM32，ADC采样程序，TIM定时触发，DMA传输，并且串口通信-rerefd fdsgdfgfghgddfhdf
ADC
- 2407实验指导书上，adc采样程序-2407 experimental guide books, adc sampling procedures
STM32-ADC
- STM32 ARM 处理器的ADC采样源代码-STM32 ARM processor ADC sample source code
ADC
- 0809ad采样 51单片机的0809ad采样学习-0809
ADC
- TQ2440开发板上实现ADC采样，系统为Wince-TQ2440 ADC sampling to achieve the development board, the system is Wince
adc
- C8051F020 ADC采样 并存储到XRAM中-C8051F020 ADC sampling and stored in XRAM
ti m4 pwm与ADC采样
- 该模块可以实现ADC采样同时控制PWM的输出。
ADC
- 单路ADC采样，适用于STM32F4， 各种功能都能实现，有兴趣可以下载(Single channel ADC sampling, applicable to STM32F4, a variety of functions can be achieved, interested in downloading)
STM32L1XX adc程序
- 基于STM32L15系列的ADC采样程序，采样精度较高(ADC sampling program based on STM32L15 series, sampling accuracy is higher)
C8051F020实现ADC采样芯片外
- C8051F020实现ADC采样芯片外的模拟电压，通过LCD显示，并通过串口发送到PC机(C8051F020 analog chip to achieve analog voltage outside the ADC, through the LCD display, and sent to the PC through the serial port. Required Downloads)
timer+ADC+DMA
- 基于STM32F407的程序，实现了通过DMA方式进行ADC采样，并通过定时器定是触发。程序中使用了ADC3-channel0,1,2;通过定时器2触发。程序已在STM32F407开发板上验证。(Based on the STM32F407 program, to achieve the ADC sampling through the DMA, and through the timer is triggered. ADC3-channel0,1,2 is used in the progra
adc
- stm32的ADC采样程序，使用于stm32F103系列(Stm32 ADC sampling procedures, used in the stm32F103 series)
07 ADC采集实验
- 实现蓝牙CC2540 adc采样功能，可以采集5V以内电压值。(Bluetooth CC2540 ADC sampling function, you can collect less than 5V voltage..)
ADC_双重_DMA
- 用DMA方式实现双重ADC采样,已经在硬件平台测试过(ADC DUAL SAMPLE, USE DMA)
C8051F310 ADC采样
- C8051F310 ADC采样程序.2. 功能:实现ADC采样芯片外的模拟电压，通过LCD显示，并通过串口（J6）发送到PC机 注：试验时把LCD电源跳线（J20_1和J20_2）联接好！(C8051F310 ADCconversion)
STM32 ADC
- STM32F103ZET6的ADC采样工程是将电压模拟量转换为数字量的过程，展示了STM32单片机AD采样软件的具体操作。(The ADC sampling project of STM32F103ZET6 is the process of converting the voltage analog to digital, and shows the specific operation of the AD sampling software of the STM32 single chip
STM32 ADC
- 基于STM32平台进行ADC采样，是对整个STM32软件配置好后，进行ADC程序编写，信号由模拟量转换为数字量，并上传到PC的过程(ADC sampling based on STM32 platform is a process of ADC programming after the STM32 software is configured, and the signal is transferred from analog to digital and uploaded to PC.)
ADC采样oled显示
- 通过12位32单片机ADC采样显示测量电压(Through 12 32 single-chip ADC sampling shows that measure the voltage)