搜索资源列表
led
- STM32F4107，点亮闪烁的LED灯(STM32F4107, Lighting up led)
LED点阵程序
- LED点阵，用于识别获取LED灯十六进制位，更方便的编写单片机的LED(LED lattice, used to identify the sixteen bits of the LED lamp, more convenient to write the LED of the single chip microcomputer)
esp8266控制led灯51单片机底层程序
- 无线模块esp8266控制led灯亮灭51单片机底层程序，只有51单片机的程序没有控制app，使用网络调试助手可以实现手机与51单片机通讯，从而达到控制led灯的亮灭，亲测可行(The wireless module esp8266 controls the LED lamp to extinguish the 51 single-chip microcomputer bottom program. Only the 51 MCU program does not control app. Us
6-不同频率闪烁1个LED灯
- 不同频率闪烁一个LED灯，基于51单片机，开发环境为keil(A LED lamp is flicker at different frequencies, based on 51 singlechip, the development environment is keil)
F310_frame
- 通过对按键的扫描 实现频率显示和led灯闪烁(Realizing frequency display and led flicker by scanning the key)
com口控制led灯
- com口发送指令来控制led的闪烁情况（库开发）(com mouth led lights control)
LED循环点亮
- LED灯循环点量（可做成跑马灯）（库函数编程）(LED light cycle point (can be made marquee) (library function programming))
led测试程序（调试通过）
- led测试程序，led灯基础点亮！stm32(LED test program, LED light foundation lighting! Stm32)
脑波控制LED
- 通过thinkgear模块采集到的脑电波，传给单片机，并控制其led灯(The EEG collected from the thinkgear module is transmitted to the microcontroller and the LED lamp is controlled.)
11-定时器timer_0中断LED显示
- 在8M晶振下,实现timer0定时操作，在规定时间内显示LED灯(Under 8M crystal oscillator, timer0 timing operation is realized, and LED lamp is displayed in the specified time.)
led
- verilog 控制 led灯 基于FPGA开发板(Verilog control LED lamp based on FPGA development board)
1、LED灯
- 适用于51单片机 不同种类LED灯 的源程序(the source codes of operating of LED for 51 single chip microcomputer)
实验3：LED流水灯
- LED流水灯PWM PWM调光程序,可以实现led灯渐变的效果用于STC89C52 上测试通过。(LEDLED water lamp PWM PWM dimming program, can achieve LED lamp gradual effect, for STC89C52 test pass.)
LED驱动
- LED是2～3伏的低电压驱动，必须要设计复杂变换电路，不同用途的LED灯，要配备不同的电源适配器。(The relationship between the forward voltage drop (VF) and the positive current (IF) curve shows that when the forward voltage exceeds a certain threshold (about 2V), that is, the usual conduction vol
流水灯
- 利用FPGA控制简单LED灯的熄灭和点亮(Using FPGA to control the extinction and lighting of a simple LED lamp)
pwmLED
- 亮度可调节LED灯，采用双色LED灯， LED调节亮度是通过调整通过它的PWM驱动电流大小得到的,节能灯一般是不能调整亮度的。本设计在项目中应用，绝对可以用。(Brightness can be adjusted LED lamp, using dual color LED lamp, LED adjust brightness by adjusting its PWM drive current size, energy saving lamps can not adjust brightne
LED
- LED单片机显示实例程序，实现基本的led灯的显示程序(LED single chip display)
bysjx
- 多路LED灯调光电路，用VHDL语言编写(Multiplex LED light dimming circuit, written in VHDL language)
LED (2)
- 初始化GPIO，使LED灯闪烁 、、、、、、、、、、、、、、、、、(Initialize the GPIO and make the LED light flicker)
3. 控制四个LED灯制成流水灯（第二个灯和上一个灯亮灭间隙不得超过0.5s）； 通过按键可以控制流水灯方向。
- 控制四个LED灯制成流水灯（第二个灯和上一个灯亮灭间隙不得超过0.5s）(3分)； 通过按键可以控制流水灯方向。（3分）