资源列表
MDS-localization
- 本代码仿真标签定位的原理，采用的技术是多维标度，里面包含了信道建立以及最小二乘法的使用-The principle of the code simulation label positioning, the use of the technology is multidimensional scaling, which contains the use of the channel and the establishment of the method of least squares
OFDM_MATLAB
- 基于MATLAB的正交频分多址ofdm系统仿真程序，可作为mimo系统仿真基础-MATLAB-based orthogonal frequency-division multiple access ofdm system simulation program can be used as the basis of system simulation mimo
FMX_UI
- delphi xe版本FMX酷炫界面代码，可参考移植-Delphi Xe version FMX cool interface code, can refer to the transplant
the-diffraction-lens-imaging
- 用衍射追迹实现衍射受限透镜成像。复习菲涅尔衍射计算的S FFT算法，掌握用衍射追迹完成理想单透镜系统成像编程计算，体会和理解透镜尺寸大小对衍射受限系统成像质量的影响。-Limited by diffraction tracing the implementation of the diffraction lens imaging.Review S- FFT algorithm of Fresnel diffraction calculation, master finish ideal sing
fftspectrum
- 基于FFT的频谱分析程序，包含感应电机定子电流数据，可直接运行-FFT based spectrum analysis program, including the induction motor stator current data, can be directly run
023prony
- prony算法的MATLAB程序，可直接运行，可设置迭代次数p，次数越大拟合效果越好-Prony algorithm MATLAB procedures, can be directly run, can set the number of iterations of P, the number of times the better the better fitting results
bishe_cphoto1_6
- MATLAB优化并叶根叶尖修正的1-6阶弦长修正结果 -MATLAB optimization and correcting the root tip 1-6 sectional chord correction result
RFID
- C#语言的RFID课程设计源码和课程设计报告书 《基于RFID的智能公交刷卡系统》-C# language RFID curriculum design source and course design report The intelligent bus card system based on RFID
Monte-Carlo
- 非时序和时序蒙特卡罗方法来求解风力发电系统可靠性-Non-sequential Monte Carlo method and timing to solve the wind power system reliability
ESO
- 根据韩京清先生提出的自抗扰理论，用matlab/simulink实现自抗扰的状态观测器，并进行模块封装。便于同学交流学习-the simulation of ESO based on matlab/simulink is covered into a block.
pinghuaMUSIC
- 基于平滑MUSIC算法的DOA估计，两个相干信号不同来向，不同信噪比对比-PINGHUA MUSIC DOA
luikun
- 包括数据分析、绘图等等,课程设计时编写的matlab程序代码，基于多相结构的信道化接收机。- Data analysis, plotting, etc., Course designed to prepare the matlab program code, Channelized receiver based on multi-phase structure.