资源列表
dyn21
- LSDYNA自定义本构模型文件, 很实用。(this is a users defined materials subroutine. It is very useful)
PLCTest2
- 三菱PLC联网组件，通讯组件适用于 基于PC高级语言的工业自动化控制系统(MITSUBISHI PLC networking components, communication components for industrial automation control system based on PC high-level language)
44754144本介绍UCOS源代码的书
- 这是介绍UCOS源代码的书籍，对学习有帮助(This is the introduction of UCOS source code books, helpful for learning)
vblue
- 一个中断处理程序的源代码 嵌入式方面的有很大的实用价值,(An interrupt handler source code embedded has great practical value,)
008-PWM-LED
- 的耶耶耶如火如荼就如同进入体育吉泰科个也太快i(ADQAQADQW VEWAFWEAWEVEW EEWEW)
4680--1
- 利用PIC18F系列单片机控制电磁阀开关的启动和断开(Use PIC18F series singlechip to control the start and disconnection of solenoid valve switch)
GY91上报姿态
- 本例程适用于GY91模块的开发。 本历程在正点原子战舰开发板上进行。 通过IIC接口（PB10,PB11）读取IMU姿态。 上位机软件为匿名上位机。(This routine applies to the development of the GY91 module.)
GTM900-C通信短信内容检测
- 用于对接收到的短信指令进行分析，并根据短信指令内容单片机的工作状态。(Used to receive SMS instructions analysis, and according to the message instruction content working state.)
adc0804
- 将模拟信号转换为数字信号传送到单片机中进行处理。(Converts analog signals into digital signals and transmits them to a single chip microcomputer for processing)
STM32F407_uCOS-II
- STM32F407ZG+UCOSIII_LWIP1.4.1并发服务器的实现(Implementation of STM32F407ZG+UCOSIII_LWIP1.4.1 concurrent server-LXC)
单片机代码
- 实现0.5秒闪一次，从0开始到f从左到右一次循环，按键程序，奇偶判断等功能(Achieve 0.5 seconds flash, starting from 0 to F, from left to right cycle, button procedures, parity and other functions)
K60_Test
- 恩智浦摄像头四轮智能车试跑程序，硬件采用山外的K60FN、MINI-Driver、鹰眼摄像头、C车模。(En Zhipu camera four wheel intelligent car test run program, the hardware uses Shan Wai`s the K60FN, MINI-Driver, eagle eye camera, C model car.)