资源列表
ADC
- 将4路模拟量4-20mA电流信号通过I\V变换将信号送至AD模块， 实现数模转换，送入单片机，经单片机处理后，再次通过DA转换和V\I变换， 输出，最后连接一个远程通讯模块连接至上位机。(The 4 analog 4-20mA current signal is transmitted to the AD module via the I\V transform, Realize digital to analog conversion, into the microcontroller,
AD-DMA
- 通过DMA把ADC结果存入DMA的RAM中，使用时可以在程序内部直接读取，比EEPROM方便快捷。包含PROTEUS仿真电路图。(Through DMA, the ADC results are stored in the DMA of RAM, and it can be read directly inside the program when using. It is more convenient and faster than EEPROM.)
高通芯片字库导出检验工程-stm32f4平台
- 通过SPI总线方式，调用字库芯片，再通过RS485显示到上位机上的结果来测试调用功能(Through the SPI bus mode, call the font chip, and then through the RS485 display to the host computer results to test the call function)
key_test.X
- 摇杆开关四个方向拨动状态判断，以及按下状态、左旋、右旋状态判断(The rocker switch switches in four directions, as well as the state of pressing, left and right)
PROTEUS仿真 输出4-20mA
- preteus仿真 4-20mA输出 加数据表(protues multisim 4-20mA)
AD7266数据采集
- 用于控制AD7266数据采集，采用Verilog语言进行程序编写(Used for AD7266 data acquisition)
mega128处理解析GPS详细数据
- mega128处理解析GPS详细数据，详细解析 GPS 信号数据(Mega128 processing, parsing GPS detailed data, detailed analysis of GPS signal data)
mega128振动器中断处理
- mega128振动器中断处理，振动器是触发式振动器，会不停产生中断(mega128 vibrator interrupts processing, and the vibrator is a trigger vibrator that interrupts continuously)
STM8推超声波探头驱动
- STM8推超声波探头驱动，探头检测距离最小2cm(STM8 drive ultrasonic probe, the probe detection distance is minimum 2cm)
TG12232-LCD屏驱动加应用代码
- TG12232-LCD 屏本身带字库，这里是采用通讯方式驱动屏显示(TG12232-LCD screen driver plus application code)
modbus文档
- 很好的modbus参考！花了半天整理的，快下载！(Good modbus reference! Finishing, quick download!)
巡线小车
- 通过寻迹实现小车的前进（不适用于所有跑道，跑道不同时要根据跑道要求进行修改），通过中断，在探测到障碍物时播放音乐。(Track the car by tracing (not for all runways, not at the same time, subject to runway modifications), by interrupting and playing music while detecting obstacles.)