资源列表
st7789init
- STM32单片机通过SPI初始化TM2.8 LCD，采用IO模拟3-line SPI RGB666模式，LVDS信号由ARM-A5提供-STM32 MCU initialization TM2.8 LCD, IO are adopted to simulate the 3-line SPI RGB666 mode, an LVDS signal provided by the ARM-A5
engine
- 基于STM32的多路舵机控制，本代码实现了stm32使用定时器同事输出16路PWM波控制舵机，并可以通过串口分别控制每个舵机-Based on the STM32 multi steering gear control, the code to achieve the use of STM32 timer colleagues output 16 PWM wave control steering gear, and can be controlled by the serial port of
G_CODE_TRANS
- 主芯片用的是STM32,G代码解析程序，用在雕刻机上-The main chip with STM32, G code parsing program, used in engraving machine
LCD12864液晶显示中文和图片
- LCD12864液晶显示中文和图片，运行程序后在模块上循环显示汉字和图片，每4秒左右更换一次显示内容。
lesson9
- STC最新系统板 LCD1602液晶时间显示（可调）按键S4选择需要调整的时间项，按下S3值增加，按下S2值减少 -STC latest system board LCD1602 LCD time display (adjustable) button S4 to the need to adjust the time item, press the S3 value increases, press the S2 value to reduce
80C51-24C02-assembler-subroutine
- 80C51 24C02汇编子程序, 用汇编语言编写，中文注释，用keil开发，实测正常使用。-80C51 24C02 assembler subroutine, written in assembly language
USB_Host_Shield_2.0-master
- usb 主控端驱动源码，鼠标，键盘，游戏手柄-usb host driver device source
RB_r8c_timer
- 瑞萨半导体R8C单片机高级定时器使用源代码 包含工程文档等-Riza semiconductor R8C s advanced timer USES the source code Include engineering documentation, etc
DS3231_STM32_MDK
- 基于STM32的DS3231源码 工程为MDK的工程-DS3231 demo base on STM32
Automated-system-program
- 这是我设计一个自动化的程序，主要是控制电机、电磁阀和传感器检测自动化系统程序-This is my design of an automated program, mainly to control the motor, solenoid valve and sensor detection automation system program
TB6600-C51
- 功能:控制步进电机全速正转、全速反转、停止、调速运行。-Function: control stepper motor full speed forward, full speed reverse, stop, speed regulation.
SMB_Slave00_AllProtocols
- MSP430 SMbus 2.0通信协议含校验（PEC),从设备响应主设备发来的命令操作，包括，读写，及程序调用-MSP430 SMbus 2.0 communication protocol including calibration (PEC), the device in response to commands the master device operation, including, reading and writing, and procedure calls