资源列表
FIR 滤波器汇编源程序
- C5000下的FIR 滤波器汇编源程序，仅供参考-C5000 under the FIR filter compilation source for reference
Vxworks_proxy
- vxworks下的sock5代理实现,c++编写，tornado环境实现。-VxWorks under sock5 Agents, c prepared tornado the Environment.
I486bus
- 基于VHDL语言开发的I486总线接口程序。实现了一个三态的总线，可保证数据的正常传输。-based on VHDL development of the I486 bus interface procedures. Implementation of a three-state bus can ensure that the normal data transmission.
1602
- 用verilog写的1602驱动 仿真已经通过，可以使用-Written in 1602 by verilog-driven simulation has been passed, you can use
clarke
- CLARKE变换 非常简单实用的DSP三相交流异步电机控制程序-CLARKE transform the DSP is very simple and practical three-phase AC induction motor control program
test_int
- pic 单片机测试程序,感应日光的亮度来调节背光灯的亮度。使画像看起来有层次感，并且光线更和谐-PIC MCU TEST IT CAN EASY DOWNLOAD TO YOU MCU AND RUN IT
5110
- 智能车诺基亚5110部分程序真的不错不错不错-Smart car Nokia 5110 part of the program is really good good good
Eclipse
- Generates an Eclipse .classpath file the given configuration.-Generates an Eclipse .classpath file the given configuration.
iic_100k
- 用verilog HDL语言描述的i2C总线程序-a iic_100k program using a verilog HDL
B2X
- 实现gps信号从大地坐标系到空间直角坐标系的相互转换，便于gps信号的滤波处理-Achieve gps signal conversion a geodetic coordinate system to the space Cartesian coordinate system, to facilitate the filtering process gps signal
stml815x
- STMC08的驱动程序，可以直接调用，用C编译程序。-STMC08 driver can directly call the C compiler.
adc
- fpga单片机通过AD转换读取电压值并通过数码管显示-The fpga single-chip microcomputer reads the voltage and displays it through a digital tube