资源列表
hanming_HDL
- 汉明码编解码的两个例程，作为单元模块分别调入所开发系统-codec of two routines, as modules were transferred by the Development System
wenkong_ds18b2011
- 这是一个有关程序控制温度及其测量的程序,可以供大家参考-This is a program controlled temperature and the measurement procedure, for your reference
16路复接器的FPGA代码
- 该复接器把16路并行信号转为一路串行信号
ledrom
- 流水灯的VHDL源代码。当设计文件加载到目标器件后，LED灯会按程序设定的规律进行闪烁。-Water lights VHDL source code. When the design document, after loading to the target device, LED lantern according to the procedure set by law of flicker.
2010061055
- renesas 外部晶振中断 用中断向量表中断-renesas interrut
cordic
- we propose a low-cost sequential and high performance architecture for the implementation of CORDIC algorithm in two computation modes. It suited for serial operation that performs conversion between polar and rectangular coordinate systems, essentia
qiangdaqi
- verilog hdl实现的三路抢答器，一个复位键，八个数码管，五个LED灯，晶振为12 MHz 采用CPLD 器件为ALTERA 的EPM7064SL-44芯片 -verilog hdl implementation of three-way Responder, a reset button, eight digital control, five LED lights, crystal is 12 MHz ALTERA CPLD device is using the E
nrf905_tx_2
- avr单片机结合nrf905无线模块的发送程序代码-code for avr-nrf905 sending message
lcd1206
- 基于51单片机的超声波测距离程序，用LCD1602显示所测距离，程序简单易懂-51 MCU-based ultrasonic distance measurement procedure, using LCD1602 display the measured distance, the program is simple to understand
Part-2
- part structure for lab 2
cnt2
- 16位二进制计数器及设计代码其测试代码（vhdl）-16-bit binary counter and design codes and test code (vhdl)
RTC_Alarm
- 基于stm32系统的唤醒程序，只需要做简单的数据修改，即可完成休眠时间的设定-Based stm32 system wakeup program, only need a simple data modification, to complete the set sleep time