资源列表
board123
- 1 本程序为DSK板的初始化过程。 2.当DSP的主时钟频率为50MHz时，计算锁定时间定时器PLLCOUNT的值，并修改相关程序。 3.将主时钟的频率分别设置为50MHz、20MHz、10MHz、5MHz，通过观察LED指示灯的闪动频率来验证程序运行是否正确。-a procedure for DSK board initialization process. 2. When DSP master clock frequency of 50MHz, calculation time lo
a2dp_sd_discover
- 蓝牙远程控制协议的运用，续传，希望对大家有用！-agreement on the use of Continuingly hope useful for all!
CPLD-CRACK-SIEMENS-200PLC
- 可用来破解分析西门子200 PLC与模块的通讯协议，基于ALTERA CPLD EPM240的设计. 需要配合分析板配套使用。-Analysis can be used to crack the Siemens 200 PLC and the communication protocol modules, based on the ALTERA CPLD EPM240 design. The need to tie in with the analysis supporting the
U18752EJ1V0AN00_78K0SKA1P_C_SRC
- three LED lights are controlled by two switches.
dianzheng
- 基于单片机的16*16点阵，从左到右移动滚动字幕-Based on Single Chip 16* 16 lattice, from left to right scrolling marquee
1
- 计算机图形学试验程序，实现二维图形变换的主要代码。ＶＣ＋＋编程的程序，适合图形学初学者使用。-Computer graphics test program to realize the main two-dimensional graphics transformation code. VC++ programming procedures, suitable for beginners to use graphics.
VGA_Controller-(2)
- vhdl VGA controller
CCP_TEST
- ccp测试程序，用在基于can的ecu标定系统中-ccp test program, the ecu can be used in calibration system based on the
IR
- 紅外線接收-Infrared receiver
24C02
- MSC51单片机AT24C02串行E2PROM的读写程序，I2C模式，-failed to translate
Untitled3
- 选定点后可以实现对图片的拉拽 错切等变换 点的个数需大于2-Of the pulling of the picture can be accomplished by the selected point after shear transformation, etc
i2c
- I2C串口程序应用，使用C语言编写，已在产品中验证-I2C serial program applications, using C language, has been verified in the product