资源列表
uarts
- RS-232 interface example for FPGA/EDA developers
shijuezanliu
- 视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequ
KeilC51function
- C51里的秘密。。。库函数。。。经常调用的函数v-the function in the keil uvision... this function usually use in the programma...
DOWNLOAD
- 基于89c58和dsp5402的hpi加载-hpi Load
0832
- 51单片机，ADC0832的A/D转换代码。ADC0832是8位分辨率、双通道A/D转换芯片。其最高分辨可达256级，可以适应一般的模拟量转换要求。-51 SCM, ADC0832 the A/D conversion code. ADC0832 8-bit resolution, dual-channel A/D converter chip. The maximum resolution of up to 256, can be adapted to the general requirem
alarm_test
- C51RF-3-PK无线ZigBee网络开发平台V5.00 ZigBee2004\ZigBee2004协议UART0中断-C51RF-3-PK Wireless ZigBee network development platform V5.00 ZigBee2004 \ ZigBee2004 agreement UART0 interrupt
4x4key_scan
- Code: 4x4 matrix key pad
kechengsheji
- 本文主要介绍是关于单片机得关于电子钟得开发，包括定时功能等-This paper describes the digital clock on the chip have to get on the development, including timing, etc.
DS18B20
- 读取温度传感器值，并将值送到显示输出或上位机-Read temperature sensor value and the value to display output or PC
ports
- 端口 嵌入式单片机端口设置 连接 VHDL实现-Port embedded microcontroller port settings to connect
DSP28_Adc
- ADC算法封装函数，能够将DSP底层设置封装在函数中，方便使用-ADC function
spline
- spline插值函数，可改变为spline函数，有助于spline图像插值算法解决-spline interpolating function, you can change the spline function helps spline image interpolation algorithm to solve