资源列表
yejin
- 单片机驱动LCD显示程序，采集DS18B20温度，在LCD上显示。
clock
- 一个电子日历时钟的汇编程序，硬件采用at89c51,ds12c887等，有三个按键用于调整日历、时钟，掉电时钟内部照常运行。有ds12c887的完整读写模块。
myPWM
- TMS320F280X硬件环境下用c语言编写的产生三相PWM波的程序-TMS320F280X hardware environment with the emergence of language c three-phase PWM wave procedures
uart_nbit
- 用verilog语言写的串口通信程序,包括收发两个模块,可用于FPGA的通信中,可通过程序设置收发的位数,有很好的扩展性.-Verilog language used to write serial communication program, including the sending and receiving two modules can be used for FPGA communications, you can send and receive through the progr
DrvSPI_A_2
- Driver for msp430 from texas
rs232uart
- RS232串口程序， 适用于51系列单片机。由c语言写成。-RS232 serial proceedings, applies to 51 series. Written by the c language.
8563
- 日历时钟芯片pcf8563用单片机管脚模拟i2c总线-Calendar clock chip with a microcontroller pin analog pcf8563 i2c bus
scan
- 分时总线切换电路。将3个四位二进制数据分时送到七段显示译码器电路和芯片外部的译码驱动电路，-Sharing the bus switching circuit
12864LCDTEST
- 这是用C语言写的12864液晶显示的驱动程序,显示内容为图文并行显示-This is written in C language, 12864 LCD driver display graphic parallel display
delayasm
- 单片机延时程序，最近做单片机程序的时候，需要若干段较为精确的延时。用C语言不容易做出，而且我用的是STC的单片机，每条指令与51相比所花的时间有差异。最后决定采用C语言中嵌入汇编的方式来解决。 -SCM delay procedure, recently made SCM process, the need for a more accurate delay several segments. With C language is not easy to make, and I use th
main
- 此程序为定时闹钟程序，可以实时的显示时间，时钟芯片DS1302，可以按键调节时间，日期，还可以设置闹铃等信息。-This procedure for the regular alarm clock procedures, can display real-time clock chip DS1302, the key, can adjust time, date, can also set the alarm information.
EV1527-PT2622-RFASK-send
- 433/315Mhz 射频发射源码。根据EV1527/PT2622的数据协议来编码发送-433/315Mhz RF transmitter source. According to the agreement EV1527/PT2622 to encode transmitted.