资源列表
Crop_it1
- it is very good program for developers
rtc
- RTC时钟程序 读写程序 -RTC Clock program to read and write procedures for
DTMF
- 基于DSP的DTMF产生与检测 C语言编程，包括产生与峰值检测。-DSP-based DTMF generation and detection of C language programming, including the generation and peak detection.
UART
- 本模块的功能是验证实现和PC机进行基本的串口通信的功能。
viterbi
- 高效率的viterbi译码，对通信中的卷积码进行译码-Efficient viterbi decoding of communications for decoding convolutional codes
1602
- LCD1602的控制，读写调用函数等-LCD1602 control
spartan_3e_uart_rx
- 使用verilog语言编写的串口接送程序，波特率9600，spartan3e板子验证。-Serial Shuttle program using verilog language, baud rate 9600, spartan3e board to verify.
main
- 通过读取ds1302信息直接显示到液晶屏上。有备用电池，断电后时间仍可以正常运行。通过串口调试软件更新时间。-Displayed by read ds1302 information directly on the LCD screen. Battery backup, power-off time can still operate normally. Serial debugging software update.
LED
- 红外遥控LED灯，汇编语言红外程序解码，控制LED亮和灭，对初学者有很大帮助。-Infrared remote control LED lamp assembly language IR program decoding, the control LED turn on and off, a great help for beginners.
LED-supersonic-wave-
- keil中通过超声波设备发送超声波和接受回波测试距离，把计算得到的数据显示在7段数码管上，如果距离接近限定的值就会报警-sent by ultrasonic equipment in keil ultrasonic to accept echo test distance calculated data is displayed on the 7-segment LED, will alarm if the distance is close to the value of the qualif
interrupts
- interrupt routine for PIC18F
FLASH
- 基于stm32编写的读写Flash的程序，内部已说明管脚分配，及spi接口，初始化等操作已经集成，用户只需要添加进工程就可使用-Based on stm32 write programs to read and write Flash, inside has pin assignment, and spi interface, initialization, etc have integrated operation, users only need to add into the projec