资源列表
UART1
- dsp2407 串口测试程序，学习2407的串口用法
data_rom
- 生成一个正弦波，使用vhdl中的宏功能模块-Generate a sine wave, the use of VHDL in the macro function modules
kechengsheji
- 1) 定时开2小时，关20分钟； 2) 环境温度高于28℃，报警并切断电源； 3 电源电压超过AC250V时，报警并切断电源报警并切断电源。 实现对功能键的选择识别和工作状态的跳转。 主要参考元件：DS18B20 LM339 -1) from time to time to open two hours off for 20 minutes 2) higher than the ambient temperature 28 ℃, the police and cut off
1
- 嵌入式系统实践 ARM7用键盘实现整数的加减乘-The practice of embedded systems using the keyboard to achieve ARM7 integer addition and subtraction by
shizhong
- 可调时间的时钟程序~调时时相应位闪烁，硬件使用的是数码管~单片机内部定时，有时间矫正~-Adjustable time clock program ~ tune from time to time corresponding bit flash, hardware using digital tube ~ MCU internal timer, time-correction ~
Radio
- radio setting for c2510
MCU-ZKB
- 占空比的测量，利用了片内定时器准确测量占空比参数。-Duty cycle measurement, use of accurate measurement of the duty cycle timer chip parameters.
jiema
- 用于红外解码，解码接收的遥控器红外信号，在单片机上用数码管显示接收的显示。-For IR decoding, decoding the received remote control infrared signal, the microcontroller on the receiver with a digital display of the display.
fifo1k_32
- vhdljichu,完成vhdl中对sdram控制器的功能-vhdljichu, completed in vhdl sdram controller functions for
1602
- 实现1602的基本功能，主要实现显示欢迎字符的功能-1602 achieve the basic functions, the main character display welcome
LX-28PIN-PWM
- PIC18F2580 PWM模块配置的参考代码！-pic18f2580 pwm mode configuration source code reference!
C51-bujingdianji
- C51 步进电机，程序设计与学习，设计与开发-C51 stepper motor, program design and learning