资源列表
ZXCJSF
- 了解二维图形裁剪的原理（点的裁剪、直线的裁剪、曲线和文字的裁剪），利用TurboC实现直线的裁剪算法。-2D graphics cutting understand the principle (point cut, straight cut, curve and the letter cutting), using Turbo achieve linear cutting algorithm.
key
- 双按键控制数码管加减一，双按键控制数码管加减一-Two-button control of digital tube plus or minus one or two-button control of plus or minus a digital tube
Simple_Verilog_Code_For_Beginner
- verilog code for beginner (adder, comparator, mux, or, and subtractor)
keyboard
- 基于stc51单片机开发试验板的第二份键盘程序。c代码-Based on the microcontroller development board test stc51 keyboard program. c code
d
- main函数中两个参数的用法 MSDN6.0中写道:argc is An integer specifying how many arguments are passed to the program from the command line. Because the program name is considered an argument, argc is at least 1.-main function uses two parameters MSDN6.0 wrote: arg
main
- 单片机P0.16低电平触发外部中断0通过按键控制-Microcontroller P0.16 low level triggered external interrupt 0 through key control
RUN-LED
- LED跑马灯，循环控制，不断显示，在飞思卡尔下-run LED,it runs all time in the type of control by the chipper of freescale
DMAC
- 该程序实现在ALTERA FPGA 上搭建NIOS系统，实现DMA 传输-The program built on the ALTERA FPGA NIOS system, DMA transfer
LoadBitmapFromBuffer
- BMP数据读入内存中，从内存生产HBITMAP-BMP data is read into memory, from memory production HBITMAP
jishuxianshi
- 用VHDL语言，实现计数显示电路的设计。-Using VHDL language, counter display circuit design.
stopwatch
- 数码秒表设计:开发板上4键从左至右为S1-S4，上电后，开始时显示 0.0 ； 利用S1按键后启动计时；S2按键后停止计时；S3按键后计时归零；最大计时 为9.9秒。计时误差小于0.2秒，显示稳定。 晶振频率：11.0592MHz -Digital stopwatch design: 4 key development board left to right S1-S4, after power is displayed at the beginning of 0.0 S
8bit
- 基于51单片机的lcd 8位数据位控制代码-Based on 51 MCU LCD 8 bits of data control code