资源列表
10ToAny
- 这个代码可以将一个10进制数转换为任意进制(16以内),非常实用-this code can be a 10-band digital conversion arbitrary 229 (16) after a very practical
jiyuPCIzanUSBzongxian
- 这是一篇论文，内容是基于PCI 和USB总线的开放式运动控制器开发，包括硬件和软件方面的设计。以及PCI与USB驱动程序的写法介绍-This is a thesis that is based on the PCI and USB Open Motion Controller development including hardware and software design. And PCI and USB driver on the way
lunhuan
- 这是个操作系统的时间片转换代码 希望可以对大家有所帮补 ^_^-this is the operating system for time-code conversion hope you all have a right to help make ^ _ ^
DSP18B20
- 基于DSP编写的DS18B20的驱动程序-prepared by the DSP-based drivers DS18B20
niossoftware
- 这是一个介绍嵌入式软件的应用，主要应用于FPGA上，介绍基于FPGA的软件编程技术文档-on embedded software applications, mainly for the FPGA, introduced FPGA-based software program files
1jwxs
- 劲舞团游戏,可以直接玩,不用下载. 劲舞团游戏,可以直接玩,不用下载.-Dance Mission games, playing directly, not downloaded. Dance Mission games, playing directly, not downloaded.
FANGFANGBOforDSP
- 基于DSP的fangbo.asm 利用定时器Timer0在XF脚产生周期1s的的方波 此程序采用100Mhz的时钟频率，产生的方波-DSP-based fangbo.asm use timer Timer0 XF feet produced in a cycle of the square's procedure using 100 Mhz clock frequency of the square wave
SINforDSP
- 基于dsp的sinx\\cosx的泰勒级数展开式，经过调试，完全可以运行-sinx \\ cosx the Taylor series expansion, after testing, we can run!
DAchange
- DA 转换 产生三角波 正旋波 梯形波（dac0832)换电路接成同相电压输出形式，其输出电压Vout=IR(1+R2/R1)。-DA conversion triangular wave generated spinning wave trapezoidal wave (dac0832) for access into the same circuit phase voltage-output type, the output voltage Vout = IR (1 R2/R1).
sanfenpin
- 这是我自己编写的三分频，也就是奇数分频，占空比为1：1，当然如果需要其它奇数分频，只要将程序里面的N和counter修改即可-This was my third prepared by the frequency, which is odd hours, frequency and duty ratio of 1:1. Of course, if the needs of other odd hours, frequency, as long as the proceedings inside
200309290729169840
- 这是我花了几天十间做的操作系统课程设计进程管理代码-This is what I spent 10 days doing the courses on operating system design process management code
1602lcmlcddriver
- 1602lcm字符液晶屏驱动演示程序,连接线图: LCM-------51 LCM-------51 LCM--------51 DB0-----P0.0 DB4-----P0.4 RS-------P2.0 DB1-----P0.1 DB5-----P0.5 RW-------P2.1 DB2-----P0.2 DB6-----P0.6 E--------P2.7 DB3-----P0.3 DB7-----P0.7 VLCD接1K2电阻到GN