资源列表
温湿度程序
- 基于STC89C52RC的温湿度读取的程序(A program for reading temperature and humidity based on STC89C52RC)
main_naive.cpp
- 完成滤波功能, 可以编译,转化为verlog代码.(This code complete filter funciton. It can be used and turned to Verilog code)
十大滤波算法
- 十大滤波算法，解决基本数值处理和参数整定(Ten large filtering algorithms to solve basic numerical processing and parameter tuning)
juchibo
- 试编程应用DAC0832输出锯齿波如图所示，锯齿波的频率为1000HZ（即周期为1ms），系统晶振为12MHZ。(假设DAC0832的芯片地址为A000H)(As shown in the DAC0832 output sawtooth wave, the frequency of the sawtooth wave is 1000HZ (that is, the period is 1ms), and the system crystal oscillator is 12MHZ. (assum
liushuideng
- 用74ls164的并行输出端接8个发光二极管，利用它的串入并出的功能，把发光二极管从左到右轮流点亮一个灯，并反复循环。（即流水灯效果）(A parallel output terminal of 74LS164 is used to connect 8 light-emitting diodes. By using its function of string in and out, the LED can turn a lamp on from left to right and circul
cell-relay
- 本技术规范规定中国联通公司CDMA直放站监控协议和直放站设备的监控接口技术要求()
yanshi5fenzhong
- 试编程采用软件延时的方法来延时5分钟。（系统时钟为6MHZ）(The trial programming uses a software delay method to delay 5 minutes. (system clock is 6MHZ))
HikVisionForAndroid-master
- 海康网络摄像头调用sdk，集成使用，简单demo。(Haikang network camera called SDK, integrated use, simple demo.)
fangshier
- 编写程序，要求使用T0，采用方式2定时，在P1.0输出周期为400μs，占空比为10:1的矩形脉冲。(The program requires the use of T0, 2 timing in mode, 400 s in the output period of P1.0, and a rectangular pulse with a space ratio of 10:1.)
dingshiqi
- 采用定时器/计数器T0对外部脉冲进行计数，每计数100个脉冲后，T0转为定时工作方式。定时1ms后，又转为计数方式，如此循环不止。假定MCS-51单片机的晶体振荡器的频率为6MHz，请使用方式1实现(A timer / counter T0 is used to count the external pulse. After counting 100 pulses, T0 turns to a timing operation. After timing 1ms, it turns to cou
bzjeqmn557
- 新形势下TD-SCDMA和WiMAX的演进研究与竞合分析()
mendel_err
- 基于家系的VCF文件，计算孩子的孟德尔错误率(calculates a child's Mendel error rate based on family-based vcf file)