资源列表
DSP-interfacing-program
- 详细进行了读卡机的DSP外围接口程序设计，-Carried out in detail the DSP peripheral interface card reader program design,
Vxware-vxworks-serial-programm
- 在vxware下的vxworks学习串口编程，学习条件： 1 开发主机，就是你的PC拉，要有com1，com2串口，2 在vmware下配置好基于x86 pcPentium的vxworks ，3 一根串口直连线， -Vxworks under the vxware learning serial programming, learning conditions: 1 development of the host, is the pull of your PC, to have com1
UART
- 通过串口实现与51单片机的通信！结合串口调试助手！-Microcontroller through the serial port communication with the 51! With serial debugging assistant!
Ultrasonic-Ranging
- 基于51单片机的ICC编译的具有温度修正的超声波测距程序，成功了-51 ICC-based MCU with temperature correction compilation of ultrasonic ranging process, successful
ADC
- 火牛开发板，ADC转换程序，测试程序，希望有帮助-AC adapter development board, ADC conversion process, testing procedures, hope that helps
SDCARD
- SD卡的读写底层驱动，对以后的开发很有帮助！-SD card read and write low-level driver, useful for future development!
STC_2Y0A21
- 夏普 红外传感器 STC12C5A60S2单片机应用 keil c代码-Sharp infrared sensors STC12C5A60S2 microcomputer application keil c code
104_PS2interface
- 51单片机通过PS2实现和102键盘的接口实验。-51 SCM 102 via PS2 keyboard interface, implementation and experiment.
ADC0804
- 利用ADC0804芯片实现模数转换，和STC89C52接口-Using ADC0804 analog to digital conversion chip
rs485a
- keil编译,单片机资料,rs485通讯-keil compiler, SCM data, rs485 communication
test_01
- 来源于infineon的资料 用于产生SVPWM信号 以控制交流伺服电机 自己修改 亲测过-this program is used for generating the SVPWM signal to control AV servo motor
core_cm3
- core_cm3.h CM3 芯片核心头文件-core_cm3.h CM3 chip core header files