资源列表
shifter_8bit
- 此实验实现一个8位的循环移位寄存器，移位的频率是2Hz，移位的方向（左移或是右移）可控。为了能显示移位的结果，我们采用一个数码管的8个段来表示这个寄存器的值。-The experimental realization of an 8-bit cyclic shift register, the shift frequency is 2Hz, the shift in the direction (left or right) control. In order to show the resul
SEG_Dynamic
- 此实验中，实现了4连体共阴数码管的动态显示。被显示的数据是以2Hz的频率递增的。每个数码管中的小数点也会以2Hz的频率循环点亮。-This experiment, to achieve the 4 piece of negative dynamic digital display. The data is being displayed increasing the frequency of 2Hz. Each LED will take a decimal point in the cycle
at90CANLIB_3_2
- this at90can32 micom library-this is at90can32 micom library
PIC-clock
- PIC单片机的电子时钟,proteus仿真。-PIC microcontroller electronic clock, proteus simulation.
PIC-SPI
- 基于PIC 单片机的SPI通信对25c040 EEPROM的读写-PIC microcontroller-based SPI communication on the 25c040 EEPROM read and write
PIC-voltage
- 基于PIC16F877单片机的电压表代码，以及PROTEUS仿真。-Voltmeter on PIC16F877 microcontroller code, and PROTEUS simulation.
counter
- 本文介绍了基于FPGA的数字频率计的设计方法，设计采用硬件描述语言Verilog ，在软件开发平台ISE上完成，可以在较高速时钟频率（48MHz）下正常工作。该数字频率计采用测频的方法，能准确的测量频率在10Hz到100MHz之间的信号。-This article describes the FPGA-based digital frequency meter design method using hardware descr iption language Verilog, ISE on t
traffic
- 交通信号灯的倒计时操作，以及温度提示功能，时间可设定-Countdown traffic signal operation, and temperature prompts, time can be set
10AD
- lpc2131外接19264 用2131自带10位AD采样显示程序-lpc2131 external 19264 2131 comes with 10-bit AD sample display program
cardprograme
- 一套开发板的完整软件演示源码及相关工具。-A complete software development board demo source code and related tools.
NRF905
- MEGA16 NRF905短距离无线传输程序代码收发-MEGA16 NRF905 short-range wireless transceiver code
SPI_10ad
- 周立功2131开发板上10位AD采样在595上显示-ZLG 2131 development board 10 samples in 595 AD on the show