资源列表
CDPlayerCtl
- CDPlayer 底层驱动,用于arm9开发-driver of CDplayer
uLwip_uCOS_S3c
- ucos+lwip在44b0+8019开发板上跑得比较较稳定的程序。是ADS的工程，编译时注意存储器空间分配。 -ucos+lwip 44b0+8019 development board to run a more stable program. The ADS project, Note that the memory space allocated at compile time.
B18raru
- 按键消抖动方法，程序稳定、有效效消抖时间快速，无干扰可直接使用。 -Buttons eliminate jitter, stable program, and effective efficiency debounce time is quick, no interference can be used directly.
ICC22430-leddA
- IAR环境下可运行的工程文件，华凡CCC2430开发系统下可运行的工程文件。 -IAR environment can run the project file, the where CCC2430 development system can run the project file.
ASTM32F10xxx-D
- 一份stm32处理器上ADC应用编程的实际例子，附附送一份详细pdf源代码说明，说明很清楚，参考价值很大 -Stm32 processor on an actual example of the ADC application programming, with comes with a detailed pdf source code instructions, instructions very clear, a great reference value
LDDS18B20P
- LPC2103 驱动 1 wire温度传感器DS18B20,,独立供电当时,并用串口显示当前得温度值，已通过测试。 -LPC2103-driven 1-wire temperature sensor DS18B20, the independent power supply and serial display have temperature values has been tested.
51jisuanqi
- 基于51单片机开发板的计算器单片机源程序-51 Calculator microcontroller source code
tongbufadianji
- 步进电机运动程序，可仿真，使用C或matlab-Stepper motor program can simulate
syss_fangzhen
- 同步电机 的方正程序，对初学者较好，可使用MATLAB或者采用其他仿真-Founder of the synchronous motor program, better for beginners to use MATLAB or using other simulation
IO-output-LED-light-
- 1-IO输出-点亮1个LED灯方法 IO output LED light -1-IO output- light up an LED lamp method IO output LED light
armboot1.0.2
- ARM MP3(LPC2148+VS1003+CH375+OLED)有频谱,用了操作系统uCOS-II(共享全部源码)-The ARM MP3 (LPC2148+VS1003+CH375+OLED,) spectrum, with the operating system uCOS-II (shared source)
FFT_Twiddles_Find_DSPrelated
- 下面是找到了基2 FFT蝴蝶旋转因子的Matlab代码。代码计算的 A 相角，在图1（c）和图2（c）所示，旋转因子的因素。我建议你开始8点DIT的FFT图1（a）通过运行代码然后运行图2中的代码为16点DIF FFT（一）。-Below is the Matlab code to find radix-2 FFT butterfly twiddle factors. The code computes the A phase angle factors that are used in t