资源列表
STM32_ADC
- 基于STM32的AD模-数转换试验，初学者可以了解STM32的模数转换器的使用-AD mode based on the STM32- digital conversion test, the beginner can understand the use of the STM32 ADC
ad
- 用单片机控制ADC0804进行数模转换，当拧动实验板上A/D旁边的电位时，在数码管的前三位以十进制方式显示出A/D转换后的数字量（8位A/D转换后数值在0~255变化）。-SCM ADC0804 digital to analog conversion, when the twist on the experimental board next to the A/D potential, the top three digital tube shown in decimal, digital A
da
- 用单片机控制DAC0832芯片输出电流，让发光二级管D12由灭均匀变到最亮，再由最亮均匀熄灭。在最亮和最暗时使用蜂鸣器分别警报一声，完成整个周期时间控制在5S左右，循环变化。-DAC0832 chip microcontroller to control the output current, light emitting diode D12 from off the uniform change to the brightest, and then goes out from the brig
STM32_USART
- 这是一个基于STM32的串口实验代码，可以直接移植，调试通过-This is a code based on the STM32 serial experiments can be transplanted directly through debugging
1602
- 实现1602第一行从左侧移入“Hello everyone!”同时第二行从右侧移入“Welcome to here!”，移入速度自定，然后停留在屏幕上。-1602 The first line moved from the left side of the " Hello everyone!" While the second line from the right side moved to the " Welcome to here!" , Moved to
1
- TMS320x28xx, 28xxx DSP Serial Peripheral Interface (SPI) Reference Guide
STM32_CAN
- 基于STM32的CAN程序，可移植到相关项目使用-CAN program based on the STM32, portable
3
- TMS320x28xx, 28xxx DSP Enhanced Controller Area Network -TMS320x28x
4
- TMS320x28xx, 28xxx Enhanced Pulse Width Modulator (ePWM) Module
STM32_I2C
- 基于STM32的I2C实验，调试成功，可移植使用-Based on the STM32 I2C experiment, the successful commissioning, portable use
5
- TMS320x28xx, 28xxx Enhanced Quadrature Encoder Pulse (eQEP) Module
STM32_USB
- 基于STM32的USB实验，移植时需要修改相应部分-Need to modify the corresponding part of the STM32 USB-based experiments, the time of transplantation