资源列表
signalgen
- 可调信号发生器，用于产生正弦波，方波，三角波和锯齿波-Adjustable signal generator used to generate sine wave, square wave, triangle wave and sawtooth
80C51-NRF24L01
- 基于80c51的NRF24L01发送和接收程序（1602 ds18b20 循迹小车）-80C51 NRF24L01 send and receive procedures (1602 Ds18b20 tracking dolly)
LCDxianshi
- 本设计主要是接收由键盘Data线发送过来的11位串行数据。用的是11位移位寄存器的基本原理。实现将由键盘发送过来的键盘扫描码转换成ASCII码，并在LCD1602液晶上显示出来。 -This design is to receive 11 serial data sent from the Keyboard Data line. Is the basic principle of the 11-bit shift register. Will be over the keyboard to se
t0_push_1khz
- 单片机实例程序：用定时器0中断方式产生1KHz频率占空比为 70的方波-SCM example program: use timer interrupt 0 1 KHz frequency can make of empty for 70 square wave than
NRF905-wireless-temperature-
- 基于80c51的NRF905无线温度采集程序（数码管 Ds18b20 ）-NRF905 wireless temperature collection procedure (bidirectional). Zip
dclock
- 数字秒表设计：设计计时范围为0.01—1h的数字秒表，程序分为分频，计数和显示三个模块-Digital stopwatch design: the design timing range of 0.01-1h digital stopwatch program is divided into three divider, counting and display module
freq
- 数字频率计：由一个测频控制信号发生器，八个有使能十进制计数器及一个32为寄存器组成-Digital frequency meter, eight energy decimal counter and a 32 for the registers: a frequency measurement control signal generator
SI4432--80C51
- 基于80c51单片机的SI4432 433M的无线发射芯片的c程序hex程序 最大传输距离1500米·-Based on the 80C51 microcontroller the SI4432 433M wireless transmitter chip c program hex program the maximum transmission distance of 1500 m
C
- 单片机控制动态数码管，通过动态扫描实现-SCM dynamic digital tube
timer0
- 单片机的中断程序，实现单片机的中断功能。-Microcontroller interrupt, the microcontroller interrupt function
matlab_code
- 无线通信FPGA设计[田耘等编着][程序源代码]-FPGA design of wireless communication [Tian Yun ed] [source code]
traffic
- verilog信号交通灯源代码，不含测试文件-this is a traffic.writing by verilog,but it is not good.