资源列表
LedKey
- STM8L的LED与按键驱动，采用了结构链-the driver of stm8l s led and button,used the chain structure
PROJECT
- Basic Code Based AVR
ethernet_test
- 以太网FPGA通信,verilog代码，实现双向通信-Ethernet FPGA communication
msp430-MCU-bootloader-Sources.tar
- msp430单片机bootloader MSP430F5438 的串口 Bootloader （非BSL下载方式）,从串口下载，两线即可，类似STC的MCU.有源码和文档--Bootloader for MSP430F5438,while it s not a BSL methed, This program download by Serial Comm, that means Two Wire download.seems like STC 51 MCU。 with a document
k60-HC05
- 用于飞卡智能车 无线调参 将重要参数通过串口蓝牙发送至上位机 Serial_Digital_Scope V2- freescale for car radio tune parameters of important parameters through the serial port Bluetooth to send first bit machine Serial_Digital_Scope V2
QD
- 四路抢答器，主持人复位之前抢答算做犯规，复位之后抢答第一个人有效，其余无效。并且均有组别显示与声音示警。-Four Responder, Responder counted reset before the host foul, the first person to answer in an effective after a reset, the rest is invalid. And have a group show with the sound warning.
qdjs
- 10s倒计时，在复位高电平期间，开始倒计时，有某信号(抢答信号)输入，则恢复到10s并保持，准备下次计时。-10s countdown, at a high level during reset and start the countdown, there is a signal (answer signal) input, then back to the 10s and remains ready for the next timing.
ug612
- xilinx的时钟约束指导，适合新手学习-xilinx clock constraint guidance documents for novices to learn
FULL_ADD
- 编写一位全加器的程序，生成器件后用BLOCK画出bdf图，最终成为四位全加器。此为实验报告，里面包括原理及框图及源程序。-Preparation of a full adder program, after generating device using BLOCK draw bdf map, eventually become four full adders. This is a test report, which includes the principle and block diag
AT86RF212CN
- at86rf212cn文档,详细描述了at86rf212cn的寄存器的功能-this is at86rf212cn.you can dont see.
weiji
- 利用TS编程软件利用8255编写程序，在实验箱上实现8个LED同时显示15-11-05。-Use TS programming software uses 8255 programming, implemented on experimental box 8 LED display 15-11-05 simultaneously.
STM32F4xx_HAL_Driver
- STM32 HAL官方文件， STM32 HAL官方文件， STM32 HAL官方文件，-STM32 HAL