资源列表
AT510-BU-98000-r0p0-00rel0
- Cortex M0 Design Start r0p0 AT510-BU-98000-r0p0-00rel0.rar
bujindianji
- arduino控制步进电机一个方向一直旋转(Arduino controls the rotation of the stepping motor)
wkq
- stm32030 HAL库驱动 oled +4路adc采集+中间值滤波算法(stm32f030 oled adc his file provides firmware functions to manage the following functionalities of the Analog to Digital Convertor (ADC) peripheral:)
SHT10单个程序-ok
- Driver of IIC device SHT10 based on STM32 platform
dac
- 基于STM32F103zet6的DAC使用程序，经过实践验证，效果不错.可以作为初学者开发资料(DAC based on the use of STM32F103zet6 program, the practice proved that the effect is good. Can be used as a beginner to develop information)
SPI-SD-Fatfs
- DSP28335 SD卡文件系统读写，使用SPI通信。(DSP28335 SD card file system read and write, using SPI communication.)
mang_ti32
- You can achieve data classification and regression pattern recognition, Machine learning routines, LCMV optimization design array signal processing.
pm2.5
- 一个基于攀藤G7传感器的PM2.5检测仪(A G7 sensor based on akebi PM2.5 tester)
ethernet_loopback
- 通过FPGA驱动千兆以太网口，完成SPARTAN6上的UDP数据包闭环测试，即通过网口发送数据包到FPGA，FPGA内部将接收到的数据返回到PC机，建议测试之前添加ARP静态绑定，FGPA内部的IP以及MAC地址在ROM里的COE文档里可以看到，发送端添加了CRC以及整体CHECKSUM的计算(Driven by FPGA Gigabit Ethernet port, UDP SPARTAN6 data packet on the closed loop test, through the ne
2_随动显示
- 跟随输入，输入多少，输出多少，而且能改变输入界面，包含interface(Follow the input, how many, how much output)
uart_test
- 收发端都采用2M波特率发送串口数据，通过PIN口直接输入输出串口数据，目的是为了跟外围高速器件完成高速的串口数据的收发，普通USB转串口的都只能支持不到1M的波特率，内部采用乒乓FIFO进行时钟域切换以及缓存(The transmitter and receiver are used 2M baud rate serial data transmission, directly through the PIN port serial input and output data, the purp
usb_rd_buffer
- FPGA（SPARTAN6）通过USB协议与开发板上的USB芯片进行数据读写测试，在上位机上可以看到USB发来的数据，也可以通过修改VERILOG代码完成数据的接收(FPGA (SPARTAN6) can read and write data through the USB chip on the development board through the USB protocol. The data sent by USB can be seen on the host computer,