资源列表
实验2 蜂鸣器实验
- 蜂鸣器简单实验，实现蜂鸣器的触发与切断，蜂鸣器实验蜂鸣器实验蜂鸣器实验蜂鸣器实验(Buzzer simple experiment Realizing the trigger and cut off of the buzzer Buzzer simple experimentBuzzer simple experimentBuzzer simple experimentBuzzer simple experiment)
FromWH - 副本
- 89C52及ADC0808实现建议交流采样(89C52 and ADC0808 to achieve the proposed AC sampling)
Keil C
- 电子密码锁 的开发编程 可以实现改密码，开锁(Development of electronic cipher lock Change cipher, unlock)
利用ADC采集通过USART1输出
- stm32f103 串口发送 adc采集的数据程序(stm32f103 serial send adc data acquisition procedures)
89c51
- 基于STC89C51的电子时钟设计 包含原理图和测试代码(The design of electronic clock based on STC89C51 includes schematic diagram and test code)
stm32f10x_temple-nb-1401011140
- stm32开发板上通过配置tim2的通道1通道2和tim3的4个通道，产生六路pwm输出波，与l298n模块相连接，控制并实现三个减速电机的变速(STM32 development board, through configuring TIM2 channels, 1 channels, 2 and tim3 4 channels, generates six PWM output waves, and is connected with L298N module, controlling an
shouhuoji
- 基于51单片机的自动售货机设计，用C语言编程(Design of vending machine based on 51 single chip microcomputer)
1_Keil_XMC1300-三相六拍
- 对永磁电机进行三相六拍控制，主要是对CCU4模块进行了设置。通过改变占空比来改变电机转速。(The three - phase six - beat control of the permanent magnet motor is mainly set up for CCU4 module.Change the motor speed by changing the proportion of the occupied air.)
2_Keil_XMC1300-电流采样
- 本程序通过对xmc1300中VADC模块的设置，采集电机三相电流值。(This program collects the three-phase current value of the motor through the setting of the VADC module in xmc1300.)
4_Keil_XMC1300-转速计算
- 通过对xmc1300中POSIF模块的设置，实现对电机转速的计算。(The calculation of motor speed is realized by setting the POSIF module in xmc1300.)
mimasuo
- 基于VHDL 4位电子密码锁的设计，在quartus II 上仿真通过(Design of 4 bit electronic cipher lock based on VHDL)
Micrium_ZC702_OS2-CAN-No-Src
- Micrium_ZC702_OS2-CAN-No-Src