资源列表
ucos serial
- 串口 的 ucos 驱动编程,应该比较有用(ucos serial driver CommGetChar CommGetTxChar CommPutChar CommBufInit)
win_ce_codes
- window ce sample code
ds1302
- 1302初始化程序,用于时钟芯片初始化,用于MSP430平台(DS1302initiative democratic code,its can be run in MSP430)
FPGA工程师面试试题集锦
- FPGA工程师面试试题集锦，适用于FPGA开发入门(FPGA Engineer Interview Suitable for the introduction of FPGA development)
完整通信好使电机转 - TM3 -
- 1.基于STM32利用DRV871驱动步进电机 2.配置SPI使STM32和DRV871通信控制步进电机 3.配置PWM控制DRV871的Step来控制步进电机的转速(1. using DRV871 to drive the stepper motor based on STM32 2. configuration SPI makes STM32 and DRV871 communication control step motor 3. configuration PWM contro
MODBUS
- 规定了8串保护板对外接设备 (UPS、逆变器或其他设备)的通信协议； 通信链路为RS485，基于Modbus RTU协议。其中外接设备为主机，8串保护板作为从机(地址固定为1)(A communication protocol for 8 series of protective panels (UPS, inverter or other equipment) is provided. The communication link is RS485, based on the Modbus
weijun
- 简单C51 控制收音机芯片 软件，里面有原理图，可以参考(A simple C51 control radio chip software)
change.tar
- 本站目前内容294万个，分类257个，凝聚了几十万会员的辛勤劳动和私家珍藏，是您程序员生涯中必备的源码库(Unless required by applicable law or agreed to in writing, software)
老司机成功程序1
- 利用线圈传感器寻地面铁线，遇到硬币报警。(The coil sensor is used to find the ground wire, and the coin alarm is encountered.)
H5
- stm32f10x串口控灯，*0000*灭.*1111*亮(Stm32f10x serial port control lamp)
test_svpwm1
- 基于dsp28027的svpwm算法测试程序，成功驱动电机。(Based on the dsp28027 SVPWM algorithm test program, the motor is successfully driven.)
DDR2_Control
- 参考例程之Verilog之实现DDR2时序控制实现，ISE开发平台完整工程(Implementation of DDR2 timing control implementation of reference routine Verilog, complete engineering of ISE development platform)