资源列表
GSM0710_driver
- WINCE平台下GSM0710协议驱动实现,可以移植到任何硬件平台.有很好的参考价值-WINCE platform GSM0710 protocol driver implementation can be ported to any hardware platform. Have a good reference value
xapp1076
- Implementing Triple-Rate SDI with Spartan-6 FPGA GTP Transceivers
OCMJ8X15-MSP430
- OCMJ8X15D液晶的基本驱动程序，能反白显示汉字及字符。-OCMJ8X15D basic LCD driver that can highlight the character and characters.
AB_Motor
- 接收航模遥控接收器2CH PWM信号,并转换为2路舵机控制信号,以控制遥控小车-Receiver model aircraft remote control receiver 2CH PWM signal, and converted to 2-way steering control signals to control the remote control car
AD-program
- 有关AD转换的DSP实验，使用28335最终实现模数转换-Experiments on DSP AD conversion, the use of 28,335 to complete the ADC
the-nRF24L01-actuation-tests-
- 基于MSP430单片机nRF24L01通讯测试-Based on msp430 monolithic integrated circuit nRF240L01 communication test
cdtanalysis
- CDT规约分析软件，能显示十进制 很好用-CDT Statute of the analysis software, can show a good use of the decimal---------------
Frequency
- 35MHz的数字频率计，用LCD1062显示，程序简单，移植性强-35 MHz digital frequency plan, LCD1062 shows, with simple procedure, portability is strong
hengliu
- 用protues编写的数控恒流源仿真程序，仿真数控恒流源。包括基于单片机的数控恒流源C语言程序。-NC protues written with constant current source simulation program, numerical simulation of constant current source. Including microcontroller-based numerical control constant current source C language
arm7
- 基于arm7的无线温度、光照检测系统，采用无线串口实现数据传输-the monitor of temprature and light with wireless
embedded-system-functional-blocks
- 嵌入式系统构件光盘资料，Jean J. Labrosse写的按键、显示、串口等模块的接口实现。-Embedded system components CD-ROM, Jean J. Labrosse wrote buttons, display, serial interface and other modules.
DIY-jiguang-ceju
- DIY基于摄像头的激光测距仪 这篇文章就是讨论如何利用一个激光笔和一个摄像头来提供一个单镜头机器视觉和测距的。-DIY camera-based laser range finder of this article is to discuss how to use a laser pointer and a camera lens to provide a single machine vision and ranging.