资源列表
calendar
- 这是一个ucGUI的万年历程序，可以在ucGUI3.90以上版本运行，界面类似于windows的日历。可以设置与保存时间，调用方法很简单，具体看MainTask里的调用。直接把例子放到工程中就可以运行了。已经在stm32平台测试通过。-This is a ucGUI' s calendar program, you can run the ucGUI3.90 above, the interface is similar to windows calendar. You can set a
src_gspi8686
- 无线模块88W8686的驱动程序，使用SPI接口程序。-Wireless Module 88W8686 driver, use the SPI interface program.
S3C2440_88W8686_spi
- s3c2440上sd8686 wifi驱动-s3c2440 on sd8686 wifi driver
ppp
- 这是全套的PPP协议的源码，运行在vxworks5.5.1上的。绝对权威，因为它是安装vxworks PNE2.2后的源代码,只要拷贝到$WIND_BASE\target\src下直接MAKE就行。-This is a full range of PPP protocol source code, running on at the vxworks5.5.1. Absolute authority, because it is installed after the vxworks PNE2.2
AD-ATMEGA48
- AVR ATMEGA48V 的AD采集程序已经调试成功-AVR ATMEGA48V AD PROGRAMER
TDA7451source
- TDA7541 驱动程序,包括不同地区，波段的设置-TDA7541 driver
AN-TI-MSP430F5438
- uCOS-II在MSP430上的移植 -uCOS-II boot msp430
Nordicpcb
- Nordic 2.4G无线芯片模块，电力设计原理图及PCB版图-Nordic 2.4G wireless chip modules, power schematic design and PCB layout
keeloq
- KEELOQ解码程序，适用于遥控编码芯片HCS301-KEELOQ decoder program
comb_key
- 自己写的一个组合按键小程序，已经实现了，采用4X4矩阵按键-Wrote it myself, a combination of key small program has been achieved, using 4X4 matrix keypad ..
v
- Verilog写的二分频电路代码，FPGA，实现将输入时钟信号的频率变成原来的1/2-Write Verilog code for the second divider circuit, FPGA, to achieve the frequency of the input clock signal into the original 1/2
RTL8306SD
- 开发网络交换机资料RTL8306SD: 内包括芯片资料和原理图，用户可以直接作板制作网络交换机。-Development of data network switches RTL8306SD: includes information on the chip and schematic, users can create network switches for the board.