资源列表
LM3SLib_I2C_Master_LM75A
- LM3S系列I2C例程：数字温度传感器LM75A LM3S系列I2C例程：数字温度传感器LM75A -LM3S series of I2C routines: Digital Temperature Sensor LM75A LM3S series of I2C routines: Digital Temperature Sensor LM75A
xilinx_fpga
- 赛林思fpga开发实例包括verilog语言和vhdl语言-The Sailin Si fpga development Examples include the verilog language and vhdl language
iso-7816
- iso-7816协议的模拟实现，即使单片机没有智能卡接口，也可以使用GPIO模拟实现该协议控制智能卡-iso-7816 protocol simulation, even if the single-chip smart card interface can also use the GPIO analog implementation of the protocol control smart card
UCOS-Ⅱfor C8051F020
- 移植到C8051F020的ucos2的源代码在C8051F020目标板上运行5小时，一切正常。-C8051F020 the ucos2 transplanted to the source code in the C8051F020 target board is running five hours, and all normal.
51MCUSJA1000
- 基于51系列单片机的can总线驱动器 sja1000的驱动程序 本程序基于c8051f系列同样有用-Based on 51 Series MCU can bus drivers drive sja1000 This procedure would also be useful based on the c8051f Series
STM8_Sinwave
- 使用STM8的定时器产生SVPWM，输出三相正玄波，只有基本功能，在实际硬件中验证过-generated SVPWM using STM8 s Timer, the output 3-phase wave, only basic functionality, proven in real hardware
emWin
- ucgui在win下模拟器源代码，可以帮助理解ucgui-ucgui under the simulator source code in win
lab1_VHDL
- VHDL数字系统设计工程实践，包含实验的原理，真值表和结构图描述，以及相关的VHDL代码。-VHDL digital system design engineering practice, including the principle of the experiment, truth table and chart descr iptions, and associated VHDL code.
DSP2
- DSB-SC信号的生成与解调 1) 用离散（DSP）的方法生成DSB信号 2) 载波频率为150KHz，音频为500Hz和2000Hz的混合音。 3) 加入高斯白噪声 （4） 语音信号 的传输。 改变抽样频率和量化台阶大小，观察重建信号以及量化噪声信号的波形；对于语音信号主观评价声音质量的变化。 -DSB-SC signal generation and demodulation 1) Discrete (DSP) methods to generate
Ssd1815
- 点阵STN LCM测试，使用51测试平台就可以了，很简单-Dot-matrix STN LCM testing, the use of 51 test platform can be a very simple
DX_PDA.328
- 有人写的stm32 做简单PDA应用 对GUI开发有启发-It was written by stm32 do simple PDA application development on the GUI has inspired
FC-G13164-1
- SSD1815/NT7502/ST7565--COG131X64液晶显示。